Design and Development of a Microgrid for Reliable Load Management with Priority-Based Solar–Battery–Grid Source Selection Using Arduino UNO
Electricity supply to colleges, institutions and remote communities is easily interrupted when one source feeds the load, and solar generation rises and falls with the sun. This paper describes a small, low-cost microgrid that combines a solar photovoltaic panel, a 12 V lead-acid battery and a mains-derived DC supply, and gives the sources a fixed priority: solar first, battery second, grid last. An Arduino UNO reads the panel and battery voltages and the load current through two voltage-sensor modules and an ACS712 Hall-effect sensor, switches DC loads through a four-channel relay module, and shows the readings on a 16×2 LCD. The prototype supply chain uses a 20 W panel, a 12 V, 7 Ah battery, and a 230/12 V transformer with a bridge rectifier and a 7805 regulator. Component ratings were fixed by design calculation for a 60 W LED load, and the source-selection rules were examined in a MATLAB/Simulink energy-management model that follows solar power, battery charge, relay status, grid and load over 48 h of simulated time. The design analysis gives about 0.93 h of battery backup at full load and about 4.4 h to recharge the battery from the panel. The work shows a simple route to automatic, renewable-first load management for small installations.
Authors
- Sakthivel N
- Sanjaykumar R
- Srihari K
- Poovinkumar R
Publication Details
- Journal
- International Journal of Latest Technology in Engineering Management & Applied Science
- Published
- 2026-11-21
- DOI
- https://doi.org/10.51583/ijltemas.2026.151100006
- Primary Topic
- Microgrid Control and Optimization
- Type
- article
- Field-Weighted Citation Impact
- 0.00