CFD Comparison of Marine Shell-and-Tube Heat Exchangers
Shell-and-tube heat exchangers (STHXs) are critical thermal management components in marine engineering, where design must balance thermal transport against the hydraulic pressure drop and auxiliary pumping power it demands. Marine-specific baffle geometries are rarely evaluated within a single validated framework that jointly addresses thermal performance, dead-zone-driven biofouling risk, nozzle-dominated pressure losses and fabrication-versus-energy cost. This study presents a Computational Fluid Dynamics (CFD) investigation and comparative thermo-hydraulic evaluation of a marine STHX. The numerical model was first validated against a semi-analytical solution for an unbaffled exchanger, then applied to three baffle configurations under identical operating conditions: a Longitudinal baffle, a Vertical Segmental baffle and a novel inclined XX-STHX design. The inclined design achieved a balanced outlet temperature while reducing pressure drop by 51% relative to the Vertical Segmental design, whose Performance Evaluation Criterion (PEC) of 1.66 confirms that its pressure penalty consumes a disproportionate share of its thermal gain. The swirling flow induced by the inclined baffles also eliminates the recirculation dead zones that drive biofouling in seawater service. An illustrative economic assessment indicates that its higher fabrication cost is justified only beyond a breakeven point of approximately 5.8 years.
Authors
- Serdar Turgut Ince (ORCID: https://orcid.org/0000-0002-7292-8292)
- Taygan Taşkıran (ORCID: https://orcid.org/0009-0000-6012-2139)
Institutions
- Yıldız Technical University (TR)
Publication Details
- Journal
- Journal of Naval Sciences and Engineering
- Published
- 2026-11-21
- DOI
- https://doi.org/10.56850/jnse.2014896
- Primary Topic
- Heat Transfer and Optimization
- Type
- article
- Field-Weighted Citation Impact
- 0.00