Numerical investigation of rock damage characteristics during combined perforation-controllable shock wave fracturing
Controllable shock-wave fracturing combined with perforation offers a potential approach for unconventional reservoir stimulation, yet the effects of perforation configuration, in-situ stress, and shock-wave loading parameters on rock damage remain unclear. In this study, a three-dimensional finite element model incorporating wellbore and perforation cavities was established using the Holmquist-Johnson-Cook (HJC) constitutive model. The model was validated against large-scale shock-wave fracturing experiments, showing qualitative agreement with the experimentally observed acoustic emission event distribution. Rock damage was quantified in terms of effective damage volume and maximum damage radius. Compared with the non-perforation case, the 6-perforation configuration increased the maximum damage radius from 0.743 to 1.276 m, while the effective damage volume changed from 0.334 to 0.310 m 3 , indicating that perforations primarily promote directional damage extension rather than increase the overall damage volume. For 4, 5, 6, 7, and 8 perforations, the effective damage volumes were 0.332, 0.305, 0.310, 0.300, and 0.290 m³, respectively, while the corresponding maximum damage radii were 0.956, 1.027, 1.276, 1.015, and 0.915 m. The effective damage volume exhibited an overall decreasing trend with increasing perforation number, whereas the maximum damage radius varied non-monotonically, reaching its highest value at six perforations. This behavior may be attributed to the combined effects of perforation orientation, stress distribution, and interactions between adjacent damage branches. Repeated shock-wave loading promoted cumulative damage, but increasing the pulse number from seven to nine produced negligible additional damage. Increasing the peak pressure from 200 to 240 MPa enlarged the effective damage volume from 0.310 to 0.411 m 3 , while the maximum damage radius remained nearly unchanged. Increasing the horizontal stress difference enhanced preferential damage propagation along the maximum horizontal principal stress direction. Furthermore, a lower-pressure, longer-duration loading mode produced greater damage volume and radial extension than a higher-pressure, shorter-duration mode. These findings suggest that perforation number and orientation should be selected according to the reservoir stress state and the desired balance between near-wellbore stimulation and far-field damage extension, while shock-wave peak pressure, pulse duration, and pulse number should be jointly adjusted to improve stimulation efficiency.
Authors
- Chuhao Huang (ORCID: https://orcid.org/0000-0001-5814-2085)
- Guohui Ren
- Chao Liu (ORCID: https://orcid.org/0000-0002-4749-5499)
- Jun Zhou
- Peng Zhao
- Kai Tang
- Benchi Li
- Lei Yu
Institutions
- Chengdu University of Technology (CN)
- State Key Laboratory of Oil and Gas Reservoir Geology and Exploitation (CN)
Publication Details
- Journal
- Scientific Reports
- Published
- 2026-11-21
- DOI
- https://doi.org/10.1038/s41598-026-81079-8
- Primary Topic
- Hydraulic Fracturing and Reservoir Analysis
- Type
- article
- Field-Weighted Citation Impact
- 0.00