Coupled Eulerian–Lagrangian modelling of extrusion and filament formation in 3D concrete printing
Predicting filament geometry is essential for dimensional control in extrusion-based three-dimensional concrete printing. This study develops a coupled Eulerian–Lagrangian (CEL) model in Abaqus/Explicit to simulate fresh mortar extrusion and deposition using a Papanastasiou-regularized Bingham law, piston-driven feeding and contact with the printing equipment. The model was assessed against an experimental benchmark comprising 12 combinations of nozzle height and travel speed, with the measured extrusion velocity prescribed for each condition. Using a common parameter set, numerical contours were compared with four experimental cross-sections per condition. The simulations captured the transition from wide, flattened filaments at small nozzle clearances to taller, rounded profiles at larger clearances. They also reproduced non-monotonic area changes associated with variations in material discharge, highlighting the combined influence of the extrusion-to-printing velocity ratio and nozzle confinement. The mean absolute percentage difference in cross-sectional area was 6.4%, with the closest agreement obtained at a nozzle height of 12.5 mm. Numerical areas were consistently underestimated, with discrepancies concentrated near the upper filament boundary. The results support the use of CEL for single-layer deposition modelling within a general-purpose finite-element environment.
Authors
- Rohola Rahnavard (ORCID: https://orcid.org/0000-0001-9399-104X)
Institutions
- University of Coimbra (PT)
Publication Details
- Journal
- Structures
- Published
- 2026-11-21
- DOI
- https://doi.org/10.1016/j.istruc.2026.113594
- Primary Topic
- Innovations in Concrete and Construction Materials
- Type
- article
- Field-Weighted Citation Impact
- 0.00