Assumption-Based Thermal-Loss Sensitivity and Metering Requirements for an LLZTO Sintering Kiln Model
This technical note examines how assumed heat-loss paths affect modeled electricity use during the final sintering of tantalum-doped lithium lanthanum zirconate (LLZTO), a garnet-type solid electrolyte for solid-state batteries. It also defines the measurements needed for an independent furnace comparison. None of the reviewed sources reported full-cycle metered electricity together with matching material composition, specimen load, thermal history, and metering scope. Energy savings relative to an external measured benchmark therefore could not be estimated. A reduced-order kiln model evaluated 64 operating cases with a six-hour hold at 1100 °C. Across the medians of eight scenario groups, the modeled reference configuration used 13.61–14.16 kWh per batch. Under the prescribed thermal-resistance assumptions, moving the same volume of insulation from the kiln door to the walls increased modeled electricity use by 0.540–0.847 kWh per batch. Removing the support thermal break increased modeled use by 0.135–0.191 kWh per batch. A scenario inspired by traditional Korean ondol heating reduced the modeled maximum temperature spread by 0.094–0.237 °C while increasing modeled electricity use by 0.043–0.083 kWh per batch. These figures describe model sensitivity to the specified inputs. The effects in a loaded furnace and the practical detectability of the temperature change remain unverified. The accompanying reproducibility package includes fixed inputs, the external-source eligibility records, simulation code, raw outputs, figure data, and SHA-256 checksums.
Authors
- Min-Gi Kim
Publication Details
- Journal
- Zenodo (CERN European Organization for Nuclear Research)
- Published
- 2026-11-21
- DOI
- https://doi.org/10.5281/zenodo.24429561
- Primary Topic
- Energy Efficiency and Management
- Type
- preprint