Microstructural evolution and mechanical behavior of modified 9Cr-1Mo steel welds fabricated via hot-wire and activated TIG hybrid technique
This study introduces an innovative hybrid welding technique combining hot-wire tungsten inert gas (HW-TIG) and activated TIG (A-TIG) processes to fabricate a defect-free joint in 12 mm-thick modified 9Cr-1Mo steel plates. The weld joint is prepared using a “V” groove configuration (35° bevel angle and 6 mm land height), with the land region joined by A-TIG and the remaining “V” groove filled by HW-TIG. The hybrid technique requires only five passes compared to nine passes for standard HW-TIG welding, thereby enhancing productivity. Microstructural analysis reveals that the A-TIG weld metal undergoes favorable in-situ modification, driven by the thermal cycles of successive HW-TIG passes, resulting in a refined microstructure in the hybrid joint. Following post-weld heat treatment, the hybrid weld metal achieves an average microhardness of approximately 240 VHN. The joint exhibits a tensile strength of 630 MPa and Charpy impact toughness of 120 J. Mechanical testing demonstrates notable flexural strength (835 MPa) and stiffness (94 GPa) of the weld in three-point bend tests, while impression creep testing confirms enhanced creep resistance compared to the base metal, with reduced total creep strain. Overall, the proposed hybrid process yields mechanical properties that exceed the minimum requirements for steam generator applications in nuclear power plants, establishing its suitability for joining thicker sections of ferritic steels with possible improvement in productivity and weld quality.
Authors
- Chitta Ranjan Das (ORCID: https://orcid.org/0000-0002-7210-498X)
- Aniruddha Moitra (ORCID: https://orcid.org/0009-0008-0737-6090)
- Hemant Kumar (ORCID: https://orcid.org/0000-0002-4132-5050)
- Gopa Chakraborty (ORCID: https://orcid.org/0000-0001-8198-5697)
- Vasantharaja Paramasivam
Institutions
- Homi Bhabha National Institute (IN)
- Indira Gandhi Centre for Atomic Research (IN)
Publication Details
- Journal
- Proceedings of the Institution of Mechanical Engineers Part E Journal of Process Mechanical Engineering
- Published
- 2026-11-21
- DOI
- https://doi.org/10.1177/09544089261510552
- Primary Topic
- Welding Techniques and Residual Stresses
- Type
- article
- Field-Weighted Citation Impact
- 0.00