Temperature-Controlled Structural and Surface Modulation of Bi/BiO x Electrocatalysts for High-Rate CO2 Electroreduction to Formate

Bismuth-based electrocatalysts are promising materials for the electrochemical reduction of CO2 to formate; however, their performance depends strongly on structural and surface properties. Herein, Bibased catalysts synthesized at 100, 120, and 150 °C were systematically investigated to elucidate the influence of synthesis temperature on their physicochemical characteristics and electrocatalytic behavior in an alkaline flow-cell reactor. Rietveld refinement revealed a temperature-dependent evolution of the bulk crystalline phases, with Bi2O2CO3 and Bi2O3 predominating in Bi-100 and Bi-120, whereas metallic Bi became the major phase in Bi-150. Raman and XPS analyses further confirmed the coexistence of metallic and oxidized Bi species, with oxidized species remaining prevalent at the catalyst surfaces. Among the investigated materials, Bi-120 exhibited the highest BET specific surface area (43.0 m2 g–1) and double-layer capacitance, together with the lowest charge-transfer resistance (36.3 Ω cm2). These properties were associated with its more favorable hierarchical morphology and superior electrocatalytic performance, reaching geometric current densities of −80, −115, and −155 mA cm–2 at −0.8, −1.0, and −1.2 V vs RHE, respectively, while maintaining formate Faradaic efficiencies of approximately 90–95%. The maximum formate production rate was 4.43 mmol m–2 s–1 at −1.2 V vs RHE. Formate and H2 were the only products detected under the investigated conditions. Stability tests revealed distinct behavior depending on the gas diffusion electrode architecture. With conventional carbon paper, the formate Faradaic efficiency decreased markedly after the first hour of operation, falling from approximately 80% to below 50% and remaining at this lower level throughout the 22 h test, consistently with electrode wetting and flooding. In contrast, a PTFE-supported Bi-120 electrode sustained operation for a total of 20 h at −150 mA cm–2, maintaining formate Faradaic efficiencies above 60%, although fluctuations in product selectivity were observed. These findings demonstrate that synthesis-temperature control provides an effective strategy to tailor the structural, textural, and surface properties of Bibased electrocatalysts, while highlighting the importance of GDE architecture and wettability management for sustained CO2 electroreduction.

Authors

Institutions

Publication Details

Journal
ACS Omega
Published
2026-11-21
DOI
https://doi.org/10.1021/acsomega.6c10495
Primary Topic
CO2 Reduction Techniques and Catalysts
Type
article
Field-Weighted Citation Impact
0.00
Controls
|||
ALL TIME
JAN
FEB
MAR
APR
MAY
JUN
JUL
AUG
SEP
OCT
NOV
article

Temperature-Controlled Structural and Surface Modulation of Bi/BiO x Electrocatalysts for High-Rate CO2 Electroreduction to Formate

Tiago A. Matias, Cauê Ribeiro, Osmando F. Lopes, Jéssica Cristina de Almeida et al.
ACS Omega
CO2 Reduction Techniques and Catalysts
article

Temperature-Controlled Structural and Surface Modulation of Bi/BiO x Electrocatalysts for High-Rate CO2 Electroreduction to Formate

Tiago A. Matias, Cauê Ribeiro, Osmando F. Lopes, Jéssica Cristina de Almeida, Daniel Raimundo Sevene, Mateus J. Tomas, Cleiton P. Martins Silva
article en

Abstract

Bismuth-based electrocatalysts are promising materials for the electrochemical reduction of CO2 to formate; however, their performance depends strongly on structural and surface properties. Herein, Bibased catalysts synthesized at 100, 120, and 150 °C were systematically investigated to elucidate the influence of synthesis temperature on their physicochemical characteristics and electrocatalytic behavior in an alkaline flow-cell reactor. Rietveld refinement revealed a temperature-dependent evolution of the bulk crystalline phases, with Bi2O2CO3 and Bi2O3 predominating in Bi-100 and Bi-120, whereas metallic Bi became the major phase in Bi-150. Raman and XPS analyses further confirmed the coexistence of metallic and oxidized Bi species, with oxidized species remaining prevalent at the catalyst surfaces. Among the investigated materials, Bi-120 exhibited the highest BET specific surface area (43.0 m2 g–1) and double-layer capacitance, together with the lowest charge-transfer resistance (36.3 Ω cm2). These properties were associated with its more favorable hierarchical morphology and superior electrocatalytic performance, reaching geometric current densities of −80, −115, and −155 mA cm–2 at −0.8, −1.0, and −1.2 V vs RHE, respectively, while maintaining formate Faradaic efficiencies of approximately 90–95%. The maximum formate production rate was 4.43 mmol m–2 s–1 at −1.2 V vs RHE. Formate and H2 were the only products detected under the investigated conditions. Stability tests revealed distinct behavior depending on the gas diffusion electrode architecture. With conventional carbon paper, the formate Faradaic efficiency decreased markedly after the first hour of operation, falling from approximately 80% to below 50% and remaining at this lower level throughout the 22 h test, consistently with electrode wetting and flooding. In contrast, a PTFE-supported Bi-120 electrode sustained operation for a total of 20 h at −150 mA cm–2, maintaining formate Faradaic efficiencies above 60%, although fluctuations in product selectivity were observed. These findings demonstrate that synthesis-temperature control provides an effective strategy to tailor the structural, textural, and surface properties of Bibased electrocatalysts, while highlighting the importance of GDE architecture and wettability management for sustained CO2 electroreduction.

ACS Omega
Instituto Superior Politecnico de Tete (MZ), Embrapa Instrumentação (BR), Universidade Federal de Uberlândia (BR)
CO2 Reduction Techniques and Catalysts
AI Navigator

Ask Laika to Summarize, Analyze, and Connect papers live on the map.

Summarize Papers & Methodologies

Extract key findings, datasets, and comparative methods across publications.

Benchmark Rankings & Visual Analytics

Rank top research institutions, authors, funders, topics, and journals by Field-Weighted Citation Impact (FWCI) and paper volume with instant charts.

Connect Distant Disciplines

Bridge topological clusters on the map to find hidden collaborative intersections.

Laika access coming soon