Effects of manufacturing techniques and surface treatments on the surface roughness and color stability of provisional restorative materials: an in vitro study
This study aimed to evaluate the effects of different surface treatment protocols on the surface roughness and color stability of provisional restorative materials fabricated using different manufacturing techniques after simulated toothbrushing and coffee immersion. Conventional laboratory-processed indirect PMMA, conventional chairside direct bis-acryl resin and digitally fabricated additive-manufactured 3D-printed methacrylate-based resin were investigated. The samples were assigned to three surface treatment protocols: polishing, polishing plus surface sealant, and surface sealant only. Surface roughness (Ra) was measured after surface treatment and after toothbrushing simulation, whereas color change (ΔE₀₀) was measured before and after the combined toothbrushing simulation and coffee immersion aging protocol. The surface morphology was qualitatively examined using scanning electron microscopy (SEM). The effects of surface treatments on surface roughness and color change were dependent on the material type and the manufacturing method. Ra values of the polished samples were higher than those of sealant-treated samples in the indirect PMMA group ( p < 0.05). In the bis-acryl group, surface treatments did not significantly affect Ra, although polishing alone increased roughness after toothbrushing. In the 3D-printed group, polishing resulted in the lowest initial Ra values, whereas toothbrushing increased the roughness of the polished samples and decreased the roughness of the sealant-treated samples. Surface treatments did not significantly influence the color stability of the PMMA, whereas significant differences in ΔE₀₀ were detected between the bis-acryl and 3D-printed materials. SEM revealed greater surface degradation in polished samples and better surface integrity in sealant-treated samples after aging. The effects of surface treatment protocols on the surface roughness and color stability of provisional restorative materials are dependent on the material type and the manufacturing method. The application of a surface sealant, particularly for 3D-printed provisional materials, may improve surface smoothness and color stability, potentially enhancing clinical performance and longevity.
Authors
- Aleyna Öykü Akbaşak Sungur (ORCID: https://orcid.org/0000-0003-3566-0423)
- Ecem Sancar (ORCID: https://orcid.org/0000-0002-2235-4681)
- Simge Alat
Institutions
- Ankara University (TR)
- Başkent University (TR)
Publication Details
- Journal
- BMC Oral Health
- Published
- 2026-11-21
- DOI
- https://doi.org/10.1186/s12903-026-10512-1
- Primary Topic
- Dental materials and restorations
- Type
- article
- Field-Weighted Citation Impact
- 0.00