Melt Strength Regulation of Cellular Structure and Thermal–Acoustic–Mechanical Synergy in ZnO/Polyethylene Composite Foams
Combining thermal insulation, sound insulation, and load-bearing capacity in lightweight polymer foams remains challenging. Here, melt-strength regulation and microchannel-assisted gas transport were combined to prepare multifunctional ZnO/polyethylene foams. Low-melt-strength polyethylene (2426H) was blended with high-melt-strength polyethylene (LD605), and porous sheets were produced by grinding and cold pressing before physically confined supercritical CO2 foaming. Preconstructed microchannels shortened gas diffusion paths, enabling a saturation time of 30 min. Varying the LD605 content from 0 to 80 wt % regulated cellular morphology and cell-wall crystallization. At 40 wt % LD605, long-chain-branch entanglement and strain hardening promoted stress-induced crystallization. The replacement of a cold-crystallization peak by a melting peak in differential scanning calorimetry, together with an increase in storage modulus from approximately 5 to 55 MPa, supported a transition from growth-dominated to nucleation-dominated foaming. The foam containing 80 wt % LD605 exhibited a thermal conductivity of 0.085 W/(m·K), a temperature difference of 61.7 °C across a thickness of 10 mm, an average broadband sound transmission loss of 37.6 dB, and a dielectric loss tangent of 0.003. Its compressive modulus and strength exceeded those of neat 2426H foam by 2336% and 653%, respectively. Finite-element simulations revealed the contributions of tortuous heat-flow paths and a refined cellular skeleton, while SHAP analysis identified structural parameters associated with acoustic and mechanical performance. These findings establish relationships between blend composition, crystallization, cellular architecture, and multifunctional performance, providing a practical route to the rapid fabrication of lightweight protective foams with combined structural and functional capabilities.
Authors
- G. Luo (ORCID: https://orcid.org/0000-0001-7879-0012)
- Ruizhi Zhang (ORCID: https://orcid.org/0000-0002-2068-5364)
- Jian Zhang (ORCID: https://orcid.org/0000-0001-7181-6021)
- Ziran Liu
- Qinqin Wei
- Yuxuan Zhu
- Mingxiao Jiang
- Xinwen Hu
Institutions
- Wuhan University of Technology (CN)
- Wuhan Textile University (CN)
Publication Details
- Journal
- ACS Applied Polymer Materials
- Published
- 2026-11-21
- DOI
- https://doi.org/10.1021/acsapm.6c04491
- Primary Topic
- Polymer Foaming and Composites
- Type
- article
- Field-Weighted Citation Impact
- 0.00
Funders
- Hubei Provincial Department of Education
- China Postdoctoral Science Foundation
- Natural Science Foundation of Hubei Province
- Science and Technology Department of Hubei Province