PROCESSOR-IN-THE-LOOP VALIDATION OF SENSORLESS DIRECT TORQUE CONTROL FOR PARALLEL FIVE-PHASE PMSM DRIVES
This paper presents a sensorless model reference adaptive system (MRAS) speed and position estimator embedded in a direct torque control with space vector modulation (DTC-SVM) scheme for two five-phase permanent magnet synchronous machines (PMSMs) connected in parallel to a single five-phase inverter. The MRAS jointly estimates rotor speed, position, torque, and stator flux for each machine, removing the need for mechanical sensors while keeping the two drives fully decoupled despite sharing one inverter. The scheme is validated experimentally through processor-in-the-loop (PIL) co-simulation, running the control algorithm on an STM32F407 Discovery board coupled to a MATLAB/Simulink SimPowerSystems plant model over a UART link. Across four test scenarios — co-directional speed tracking, counter-rotating operation, alternating high-speed reversal, and low-speed operation — the estimator tracks the reference speeds closely (peak transient error below 0.1 rad/s, settling below 0.02 rad/s at low speed), the stator flux remains constant near 0.3 Wb, and the two machines remain fully decoupled: load, speed, or direction changes on one drive produce no measurable disturbance on the other.
Authors
- Tounsi Kamel
- Maamar Souaihia (ORCID: https://orcid.org/0000-0002-0413-1636)
Institutions
- Hassiba Benbouali University of Chlef (DZ)
Publication Details
- Journal
- REVUE ROUMAINE DES SCIENCES TECHNIQUES — SÉRIE ÉLECTROTECHNIQUE ET ÉNERGÉTIQUE
- Published
- 2026-11-20
- DOI
- https://doi.org/10.59277/rrst-ee.2026.4.6
- Primary Topic
- Sensorless Control of Electric Motors
- Type
- article
- Field-Weighted Citation Impact
- 0.00