A cross-method performance study: DOE-based regression, physics-based simulation, and sensor-based machine learning for injection molding quality prediction
Quality monitoring in injection molding can be achieved through various modeling techniques, yet no clear framework exists to guide practitioners in selecting the most appropriate approach for their specific application requirements. Understanding which data sources and modeling strategies are needed, based on the required degree of accuracy, transparency, and cost constraints, remains an important and unresolved research gap in the industry. This study aims to address this challenge by presenting a comparative analysis of three predictive modeling methodologies for evaluating injection molded part quality, each representing a distinct level of complexity and cost: (1) multivariate regression modeling using design of experiments (DOE), the simplest and lowest-cost approach relying solely on machine data, which achieved an average MAPE of 0.95%; (2) physics-based simulation using Moldex3D, which requires commercial software licensing and performed well under normal fill conditions but was substantially penalized by short shot cycles that the simulation could not accurately represent, resulting in an average MAPE of 2.03%; and (3) machine learning (ML), utilizing a nested deep learning architecture based on long short-term memory (LSTM) networks, the most resource-intensive approach requiring in-mold sensors and data acquisition systems, which achieved an average MAPE of 0.27% on the selected comparison cycles, including short shots. These results highlight the complementary capabilities of the three modeling approaches: each approach addresses different needs along the manufacturing lifecycle, and the optimal selection depends on the balance of predictive accuracy, process coverage, and infrastructure cost.
Authors
- Xiangyu Hu (ORCID: https://orcid.org/0000-0002-1599-5667)
- Saeed Davoudabadi Farahani (ORCID: https://orcid.org/0000-0002-2058-3747)
- Yan Tong (ORCID: https://orcid.org/0000-0002-6677-8646)
- Hongpeng Yang (ORCID: https://orcid.org/0009-0001-9101-3063)
- Sai Aditya Pradeep (ORCID: https://orcid.org/0000-0002-0965-0355)
- Luke Shannon
- Dhanashree Shinde
- Xiaoyi Liu
Institutions
- University of South Carolina (US)
- Clemson University (US)
- University of Delaware (US)
Publication Details
- Journal
- The International Journal of Advanced Manufacturing Technology
- Published
- 2026-11-21
- DOI
- https://doi.org/10.1007/s00170-026-19582-5
- Primary Topic
- Injection Molding Process and Properties
- Type
- article
- Field-Weighted Citation Impact
- 0.00
Funders
- Clemson University
- Society for Community Research and Action