Mechanical characterization and constitutive modelling of 8011-O aluminium alloy sheets for fin forming
Accurate representation of anisotropy, strain rate sensitivity and fracture is needed to simulate the forming of thin aluminium fins. This study characterizes 8011-O aluminium alloy sheets with a thickness of 0.3 mm and develops material descriptions for fin forming. Room-temperature uniaxial tensile tests were conducted along seven in-plane orientations, and tests in the rolling direction covered strain rates from 10⁻⁴ to 10³ s⁻¹. Shear and notched tensile tests were used to characterize fracture under different stress states. The measurements showed pronounced directional variation in yield stress and plastic strain ratio, together with an increase in flow stress with strain rate. A modified Hill48 formulation was fitted to the directional yield stresses and plastic strain ratios, and a Johnson-Cook constitutive model with a polynomial strain rate coefficient was introduced. A Johnson-Cook fracture model was calibrated using the fracture tests. These material descriptions were then used in finite element simulations of fin piercing and flanging. The simulations identified localized thinning near the punch radius. Comparison with forming experiments gave a maximum relative error of 9.68% in the thinning ratio. Both the simulations and experiments showed fracture at a punch speed of 500 mm s⁻¹. The results provide a basis for assessing thickness variation and fracture during 8011-O aluminium fin forming.
Authors
- Yingsheng Li (ORCID: https://orcid.org/0000-0002-7803-4935)
- 薛克敏
- Mengchen Zhu (ORCID: https://orcid.org/0009-0005-7440-3026)
- Xu Cheng
- Lin Zhong
- Baisong Liu
- LI Ping
- Yang Wang
Institutions
- Hefei University of Technology (CN)
Publication Details
- Journal
- Research Square
- Published
- 2026-11-20
- DOI
- https://doi.org/10.21203/rs.3.rs-11633989/v1
- Primary Topic
- Metal Forming Simulation Techniques
- Type
- preprint