Effects of Illumination and Resonance Spectral Conditions on the Sensing Performance of Guided-Mode Resonance Sensors
Intensity-based interrogation is a simple, inexpensive readout strategy for guided-mode resonance (GMR) sensors; however, its performance depends on the overlap between illumination and resonance spectra. We developed an overlap integral model that quantifies a GMR sensor’s transmission intensity as a function of illumination wavelength, illumination and resonance full widths at half maximum (FWHMs), resonance efficiency, and wavelength offset from the resonance dip. By using normalized intensity sensitivity as a figure of merit, we demonstrated that positioning the illumination wavelength on the linear flank of the resonance yields higher sensitivity than centering it on the resonance dip for small GMR resonance FWHMs, especially under small refractive-index changes. Sensitivity increases with resonance efficiency and decreases with illumination FWHM but varies non-monotonically with resonance FWHM, revealing trade-offs among sensitivity, signal magnitude, and dynamic range. These predictions were experimentally validated using a GMR-integrated polydimethylsiloxane microfluidic chip interrogated by a tunable-FWHM monochromator and 0–10% sucrose solutions. The measured transmittance changes reproduced the predicted behaviors and the sensitivity gain from reducing the illumination linewidth from 3 to 1 nm. Overall, the results guide the selection of illumination offset, source linewidth, and resonance linewidth in the design of compact, spectrometer-free GMR sensors for point-of-care diagnostics.
Authors
- Shih-Chuan Huang
- Cheng-Sheng Huang
Institutions
- National Yang Ming Chiao Tung University (TW)
Publication Details
- Journal
- Sensors
- Published
- 2026-11-19
- DOI
- https://doi.org/10.3390/s26227332
- Primary Topic
- Advanced Fiber Optic Sensors
- Type
- article
- Field-Weighted Citation Impact
- 0.00