Effect of a low plasticity ball burnishing tooling system with low plasticity on the surface integrity of Ti-6Al-4V alloy
Fatigue fractures often initiate, propagate, and culminate in failure when mechanical components are exposed to dynamic stresses. To improve components’ fatigue performance, several surface-improvement methods are available. One such method gaining popularity in the surface treatment sector is low-plasticity burnishing (LPB), which offers benefits over shot peening, low-plasticity ball burnishing, and deep rolling. This work’s objective is to examine the consequences of using a low-plasticity ball burnishing tooling method to burnish the Ti-6Al-4V material on surface integrity. Optical microscopy was used to analyse the microstructural characteristics of the Ti-6Al-4V alloy before and after low-plasticity burnishing. When compared to the unburnished specimen, the optimal LPB conditions of 15 MPa burnishing pressure, 2 burnishing passes, and 500 mm/min feed rate resulted in a 34% improvement in microhardness and a 23% decrease in surface roughness.
Authors
- R Harish (ORCID: https://orcid.org/0000-0002-6738-6310)
- D. Shivalingappa (ORCID: https://orcid.org/0000-0003-1564-7133)
- Subramanian Pillappan Shanmuganatan (ORCID: https://orcid.org/0000-0001-8032-0781)
- Melwyn Rajesh Castelino (ORCID: https://orcid.org/0000-0002-7007-2056)
- C. Solaimuthu
- Banakara Nagaraj
- Nimona Hailu
- Swetha Radha Srikakolapu
- R. Anilkumar
- Rahul Kumar
Institutions
- Nitte University (IN)
- Bule Hora University (ET)
- Dayananda Sagar University (IN)
- Dayananda Sagar College of Engineering (IN)
- Aditya University (IN)
- Ballari Institute of Technology & Management (IN)
Publication Details
- Journal
- Journal of Materials Science Materials in Engineering
- Published
- 2026-11-19
- DOI
- https://doi.org/10.1186/s40712-026-00639-y
- Primary Topic
- Surface Treatment and Residual Stress
- Type
- article
- Field-Weighted Citation Impact
- 0.00