Surface integrity and recast layer characteristics of Syalon-501 during EDM
Electrical discharge machining (EDM) is widely utilised non-traditional machining technique for conductive ceramic composites (CCCs), since it can machine complex geometries without imposing high mechanical strains. The impact of gap voltage (35.5–45.5 V, current (3–7A), pulse-off-time (3–7 μs), pulse-on-time (6–10 μs), and dielectric pressure (15–19 kg/cm 2 ) on the recast layer and surface morphology of Si 3 N 4 -TiN (Syalon 501) CCCs were studied by L25 orthogonal array and scanning electron microscopy (SEM). From the SEM results, it seems that the increase of current from 3 to 7 A significantly increased the discharge energy, leading to deeper craters, thicker recast layers, wider microcracks and resolidified molten droplets. Similarly, localized melting and material redeposition increased with increasing the spark-gap voltage from 35.5 to 45.5 V, resulting in an uneven surface morphology. Higher dielectric pressure (19 kg/cm 2 ) improved flushing efficiency and reduced the thickness of adherent debris and recast layer. Short pulse-off periods (3–4 μs) limited dielectric deionization, caused secondary discharges and increased debris entrapment. The surface integrity was found to be maximum at 4A, 7µs pulse-off-time, 7µs pulse-on-time, 42 V spark-gap voltage and 16 kg/cm 2 dielectric pressure. At the conditions the machined surface resulting fine craters, low microcracks, fewer microvoids and a thin continuous recast layer. The results show clearly the high dependence of the thermo-induced surface degradation on the EDM discharge parameters.
Authors
- C. Arun (ORCID: https://orcid.org/0000-0002-3634-5575)
- Thangarajan Sivasankaran Senthilkumar (ORCID: https://orcid.org/0000-0003-2498-0480)
- Lakshmanan Selvarajan (ORCID: https://orcid.org/0000-0003-3472-7374)
- B. Prakash (ORCID: https://orcid.org/0009-0005-2540-9405)
Institutions
- Karpagam Academy of Higher Education (IN)
Publication Details
- Journal
- Surface Engineering
- Published
- 2026-11-19
- DOI
- https://doi.org/10.1177/02670844261508225
- Primary Topic
- Advanced Machining and Optimization Techniques
- Type
- article
- Field-Weighted Citation Impact
- 0.00