Monolith, porous bead, membrane or fibre? A comparative characterisation of four oligo-dT affinity chromatography matrices for mRNA capture
Oligo-deoxythymidine (oligo dT) affinity chromatography is the most widely used capture step for in vitro transcribed mRNA and is now offered in four stationary-phase architectures, yet, to our knowledge, no published study has compared all four. We characterised a monolith, perfusive porous beads, a membrane adsorber and an electrospun cellulose fibre adsorber with a short (eGFP, 930 nt) and a long (SARS CoV 2 spike, S 2P, 4284 nt) mRNA. After screening the loading salt (NaCl or guanidine hydrochloride, Gu HCl), we mapped load flow rate, load concentration and Gu HCl concentration with response surface designs and compared the formats at near-optimal conditions. Gu HCl gave a higher peak recovery than NaCl in seven of the eight matrix construct combinations. At the near-optimal runs, the fibre adsorber recovered 17.9 mg eGFP and 13.3 mg S 2P per mL of bed, 2.3 to 2.6 fold the membrane and 3.5- to 4.8-fold the monolith and beads (p < 0.001); these are yields at loads that differed between formats (5 to 20 mg/mL of bed), not binding capacities. Productivity ranked fibre > membrane > monolith > beads (0.314 to 0.035 mg/mL/min for eGFP). The membrane and fibre adsorber lost yield sharply above 0.4 to 0.6 M Gu HCl, whereas the monolith and beads declined gradually. In an amortised cost model at baseline cost inputs, the fibre adsorber was the least expensive format per milligram of purified mRNA at every number of device cycles (USD 114 to 140/mg for single use and 78 to 92/mg at 20 cycles), and the membrane the most expensive. A one at a time sensitivity analysis over wide ranges of the mRNA feed cost, the labour and facility rate, the device price and the number of cycles per device left the fibre adsorber the least expensive format in almost every combination examined, with the mRNA feed cost the dominant input. Only the monolith and beads are currently marketed as GMP grade, process scale materials, so the choice of format depends on whether capacity, productivity, cost or manufacturing readiness takes priority.
Authors
- Adithya Nair (ORCID: https://orcid.org/0000-0002-2592-116X)
- Mabrouka Maamra (ORCID: https://orcid.org/0000-0003-0077-9299)
- Jixin Qu (ORCID: https://orcid.org/0009-0002-5293-0413)
- Manoj Pohare (ORCID: https://orcid.org/0000-0003-2272-9946)
- Shady Hamed
- Zoltan Kis
Institutions
- University of Sheffield (GB)
Publication Details
- Journal
- bioRxiv (Cold Spring Harbor Laboratory)
- Published
- 2026-11-19
- DOI
- https://doi.org/10.64898/2026.11.17.767441
- Primary Topic
- Protein purification and stability
- Type
- preprint