Sol–Gel Synthesis of Cerium-Doped Tio2 Nanoparticles with Enhanced Visible-Light Absorption as Candidate Electron Transport Materials for Perovskite Solar Cells

Titanium dioxide is the most widely used electron transport layer (ETL) in n–i–p perovskite solar cells (PSCs), but its wide band gap, modest electron mobility and high density of recombination-active defects limit device performance. In this work, pure and cerium-doped TiO2 (Ce:TiO2) nanoparticles with nominal Ce contents of 1.2, 1.5, 1.8, 2.1 and 2.4 mol% were prepared by an acetic-acid-modified sol–gel route followed by calcination at 450 °C, and their structural, morphological and optical properties were characterised as a materials-level assessment; no solar-cell devices were fabricated. X-ray diffraction showed that all samples crystallised as single-phase anatase (JCPDS 21-1272) with no detectable CeO2 or Ce2Ti2O7 reflections, while peak broadening indicated a decrease in the Scherrer crystallite size from 11.1 nm (pure TiO2) to 5.5–7.4 nm in the doped samples (estimated uncertainty ≤ ±0.3 nm from the diffractometer step size; values are lower-bound estimates). Scanning electron microscopy showed agglomerates of approximately 130–350 nm built from finer primary crystallites, and FTIR spectra confirmed the Ti–O–Ti lattice framework and indicated increased surface hydroxylation upon doping. Pure TiO2 showed an indirect optical band gap of 3.31 eV. Ce incorporation increased sub-band-gap absorption across the visible region, raising the absorbance at 500 nm from 0.12 to 0.46–2.63 with increasing Ce content. Because this absorption masks the fundamental absorption edge, the band gap of the doped samples could not be determined, and the enhanced absorption is attributed to Ce 4f- and defect-related states rather than to band-gap narrowing. The reduced crystallite size and the dopant-related sub-gap states indicate that low-level Ce doping is a simple, solution-processable route for modifying TiO2; whether these changes improve electron transport or photovoltaic performance remains to be established in device studies.

Authors

Institutions

Publication Details

Journal
International Journal of Research and Innovation in Applied Science
Published
2026-11-19
DOI
https://doi.org/10.51584/ijrias.2026.11100117
Primary Topic
TiO2 Photocatalysis and Solar Cells
Type
article
Field-Weighted Citation Impact
0.00
Controls
|||
ALL TIME
JAN
FEB
MAR
APR
MAY
JUN
JUL
AUG
SEP
OCT
NOV
article

Sol–Gel Synthesis of Cerium-Doped Tio2 Nanoparticles with Enhanced Visible-Light Absorption as Candidate Electron Transport Materials for Perovskite Solar Cells

C. V. Krishna Reddy, K. Jhansi Rani
International Journal of Research and Innovation in Applied Science
TiO2 Photocatalysis and Solar Cells
article

Sol–Gel Synthesis of Cerium-Doped Tio2 Nanoparticles with Enhanced Visible-Light Absorption as Candidate Electron Transport Materials for Perovskite Solar Cells

C. V. Krishna Reddy, K. Jhansi Rani
article en

Abstract

Titanium dioxide is the most widely used electron transport layer (ETL) in n–i–p perovskite solar cells (PSCs), but its wide band gap, modest electron mobility and high density of recombination-active defects limit device performance. In this work, pure and cerium-doped TiO2 (Ce:TiO2) nanoparticles with nominal Ce contents of 1.2, 1.5, 1.8, 2.1 and 2.4 mol% were prepared by an acetic-acid-modified sol–gel route followed by calcination at 450 °C, and their structural, morphological and optical properties were characterised as a materials-level assessment; no solar-cell devices were fabricated. X-ray diffraction showed that all samples crystallised as single-phase anatase (JCPDS 21-1272) with no detectable CeO2 or Ce2Ti2O7 reflections, while peak broadening indicated a decrease in the Scherrer crystallite size from 11.1 nm (pure TiO2) to 5.5–7.4 nm in the doped samples (estimated uncertainty ≤ ±0.3 nm from the diffractometer step size; values are lower-bound estimates). Scanning electron microscopy showed agglomerates of approximately 130–350 nm built from finer primary crystallites, and FTIR spectra confirmed the Ti–O–Ti lattice framework and indicated increased surface hydroxylation upon doping. Pure TiO2 showed an indirect optical band gap of 3.31 eV. Ce incorporation increased sub-band-gap absorption across the visible region, raising the absorbance at 500 nm from 0.12 to 0.46–2.63 with increasing Ce content. Because this absorption masks the fundamental absorption edge, the band gap of the doped samples could not be determined, and the enhanced absorption is attributed to Ce 4f- and defect-related states rather than to band-gap narrowing. The reduced crystallite size and the dopant-related sub-gap states indicate that low-level Ce doping is a simple, solution-processable route for modifying TiO2; whether these changes improve electron transport or photovoltaic performance remains to be established in device studies.

International Journal of Research and Innovation in Applied ScienceVol. 11(10)
Rayalaseema University (IN)
TiO2 Photocatalysis and Solar Cells
AI Navigator

Ask Laika to Summarize, Analyze, and Connect papers live on the map.

Summarize Papers & Methodologies

Extract key findings, datasets, and comparative methods across publications.

Benchmark Rankings & Visual Analytics

Rank top research institutions, authors, funders, topics, and journals by Field-Weighted Citation Impact (FWCI) and paper volume with instant charts.

Connect Distant Disciplines

Bridge topological clusters on the map to find hidden collaborative intersections.

Laika access coming soon