Design, Fabrication, and Structural Validation of a Formula Student Front Wing: A Vacuum-Assisted Hand Layup Case Study
This paper presents an integrated design, manufacturing, and validation methodology for aerodynamic components, demonstrated on a Formula Student front wing built within a USD 192 budget. A Computational Fluid Dynamics (CFD) workflow, validated against measured forces on a double-element wing in ground effect within 3% in downforce, was applied in a target-driven sequence: a four-parameter two-element configuration reached approximately 166 N in 3D, below the 260 N target, motivating a seven-parameter, 600-point Design of Experiments for a three-element configuration. The final design predicted 270.0 N of downforce and 25.7 N of drag, with a 40.7:59.3 front-to-rear vehicle split against the 40:60 target. A scaled wind tunnel test confirmed the drag level only qualitatively, owing to Reynolds-number and ground-effect mismatch. Finite Element Method (FEM) analysis confirmed compliance with the Formula SAE (FSAE) deflection rule T8.3.1. A decision matrix selected 162 g/m2 twill glass fibre, wet-laid with epoxy over an expanded polystyrene core and vacuum-consolidated at about 0.8 bar below atmospheric on a fume-hood vacuum line, as the available pump could run for only 15 min. The largest airfoil of the 8.5 kg wing deflected 3.25 mm under the 200 N regulatory load, well within the 10 mm limit. The workflow provides a reproducible, low-cost route from vehicle-level targets to a physically verified component.
Authors
- Mohamed Serry (ORCID: https://orcid.org/0000-0003-2856-9082)
- Jana Hussein
- Omar A. Abdelaziz (ORCID: https://orcid.org/0000-0002-4418-0125)
- Veronika Sameh
- Yomna Abdelaal
- Mostafa El-Tohamy
- Omar Hussien
- Mina Youssef
Institutions
- American University in Cairo (EG)
Publication Details
- Journal
- Vehicles
- Published
- 2026-11-19
- DOI
- https://doi.org/10.3390/vehicles8110305
- Primary Topic
- Engineering and Materials Science Studies
- Type
- article
- Field-Weighted Citation Impact
- 0.00