Design Features and Energy Assessment of Sandvik Hydraulic Rock Drills
The paper examines the design features and the energy characteristics of Sandvik hydraulic rock drills (HL510 and RDX5) on the basis of the manufacturer's published data, without numerical modelling. The impact energy of a single blow is estimated as the ratio of percussion power to percussion rate and amounts to approximately 271 J for the HL510 and 299 J for the RDX5. It is shown that the 25 % higher percussion power of the RDX5 is the product of a 10 % higher blow energy and a 13.6 % higher percussion rate. Simplified analytical relations for the striker velocity, the stress-wave amplitude in the drill rod and the energy transfer between lumped masses are used to compare the serial two-mass percussion system with a three-mass scheme that has an additional low-mass striker. The fatigue loading of the striker and the shank is estimated from the number of load cycles, and recommendations for operation are given. A programme of further numerical research for hard rock is outlined. Keywords hydraulic rock drill percussion mechanism impact energy drill rod stress wave three-mass percussion system energy efficiency
Authors
- Volodymyr Kuklich
- Medina Tulegenova
Institutions
- Abylkas Saginov Karaganda Technical University (KZ)
Publication Details
- Journal
- Zenodo (CERN European Organization for Nuclear Research)
- Published
- 2026-11-19
- DOI
- https://doi.org/10.5281/zenodo.24378923
- Primary Topic
- Geotechnical and Geomechanical Engineering
- Type
- article
- Field-Weighted Citation Impact
- 0.00