BiPathCPG: A Novel Load-Sharing Design Architecture for Compound Planetary Gearboxes
Quasi-Direct Drive (QDD) actuators are widely used in legged robots due to their low reflected inertia, high backdrivability, and high torque density, commonly employing planetary or cycloidal gearboxes. Single-stage planetary gearboxes offer high efficiency but limited torque density; multi-stage designs improve torque density at the cost of efficiency; and cycloidal gearboxes provide high stiffness but suffer from torque ripple. Compound Planetary Gearboxes (CPG) offer a compromise, but conventional designs result in increased actuator width, mass, and reduced torsional stiffness in 3D-printed actuators. This paper proposes the BiPath Compound Planetary Gearbox (BiPathCPG), a novel architecture that introduces an idle second-stage sun gear and load-sharing second-stage planets within the otherwise unused space of a conventional CPG to simultaneously improve stiffness, reduce actuator width, and reduce mass. An optimization framework computes BiPathCPG parameters for a given motor and target gear ratio. The architecture is validated through a 3D-printed proof-of-concept actuator design, benchmarked against a conventional CPG using custom-built test rigs. The BiPathCPG achieves a torsional stiffness of 1394 Nm/rad, a 1.70x improvement over the conventional CPG, with a 32% reduction in backlash, 25 g lower mass, and approximately 6.4 mm reduction in axial width, while achieving a peak stall torque of 36.49 Nm.
Authors
- Shishir Kolathaya (ORCID: https://orcid.org/0000-0001-8689-2318)
- Deepak Kapa
- Suryank Joshi
- Aman Singh
- Mayank Goswami
- Saketh Vegesna
Publication Details
- Journal
- arXiv (Cornell University)
- Published
- 2026-11-18
- DOI
- https://doi.org/10.48550/arxiv.2611.24142
- Primary Topic
- Gear and Bearing Dynamics Analysis
- Type
- preprint