Development of Cement Mortar Incorporating a Natural Biopolymer for Potential Use in Extrusion-Based 3D Printing
This study developed and evaluated cement mortar with a natural biopolymer Ceratonia siliqua seed gum, which could be used in extrusion-based 3D printing. A total of 9 formulations included a plain control, chemical-admixture control and seven dosages of biopolymer, 0.1 to 0.8% by cement mass. Cement:sand ratio and nominal added-water-cement were about 1:1.25 and 0.32, respectively. Flow-table observations and manual mass extrusion through a 30 mm outlet were made; the chemically modified compression batches contained an accelerator. The rate of mass extrusion was 2.92 g/s for plain mortar and 6.54 g/s for the admixture control and reached its maximum with 0.3% biopolymer (7.08 g/s). The corresponding three-day strengths were 20.53, 28.83 and 30.25 MPa. The extrusion rate and strength of the 0.3% formulation were 8.28% and 4.93% higher than the admixture control, respectively. Increased dosages raised recorded flow-table D2 values but decreased extrusion rate and strength. The dosage of 0.3% is thus a candidate to be tested further and not a proven optimum. The limitations of interpretation include manual actuation, missing replicate data, and missing specimen documentation, whereas the pumpability, multilayer buildability and interlayer performance are not verified.
Authors
- John Oluwole Labiran
- Ajibode Daniel Olayimika
Institutions
- University of Ibadan (NG)
Publication Details
- Journal
- Iconic Research and Engineering Journals
- Published
- 2026-11-19
- DOI
- https://doi.org/10.64388/ire1725348
- Primary Topic
- Innovations in Concrete and Construction Materials
- Type
- article
- Field-Weighted Citation Impact
- 0.00