Comparative study of local dry underwater and dry gas metal arc welding of mild steel
Purpose In recent years, it has been demonstrated that service repair defect resistance and geometric adaptability can be greatly enhanced using advanced drainage devices such as miniaturised nozzle systems and double-chamber patch-welding designs. These advances encourage further experimental research with real-world, low-cost system configurations. The present work addresses this need by conducting a comparative experimental study of gas metal arc welding mild steel in air and in a local, dry, underwater environment. A custom nozzle system was designed to produce a local dry zone around the gas metal arc welding (GMAW) torch, and weld beads were fabricated under three conditions. The study assesses the effects of the parameters on weld-bead morphology, penetration behaviour, reinforcement, hardness distribution and optical micro-structure, while maintaining a practical process that balances feasibility and weld quality. The study aims to understand the potential of local dry underwater GMAW as an economical method for marine repair and fabrication applications by correlating water depth and parameter selection with the observed macroscopic and microstructural responses. The outcomes are intended to contribute to the ongoing development of portable underwater welding solutions that can deliver acceptable weld integrity without the logistical burden of full hyperbaric systems. Design/methodology/approach In the present investigation, a design and implementation of a drainage nozzle system for local dry underwater GMAW was carried out, and then, a systematic assessment of welding parameters, microstructural evolution and mechanical performance of the welded joints was performed. Based on experimental observations and analyses, the following conclusions are drawn: The developed GMAW-based local dry underwater welding setup, with the addition of a drainage nozzle, successfully produced sound weld joints with minimal spatter, no porosity and no surface or macroscopic cracks, demonstrating the effectiveness of the nozzle design in providing a stable local dry environment. By optimising the main process parameters (welding current, voltage and welding speed), stable welding operations were achieved at water depth of 50 mm. Optimum conditions provided acceptable bead geometry, penetration and weld quality in sub-merged conditions. Findings Overall, the study has shown that controlled parameter optimisation for local dry underwater GMAW can produce defect-free welds with predictable microstructural and mechanical properties, suitable for underwater repair and fabrication applications. Increased heat input at greater depths resulted in relatively lower hardness than moderate heat input conditions, highlighting the combined influence of thermal input and cooling rate on weld properties. Overall, the study confirms that controlled parameter optimisation in local dry underwater GMAW can achieve defect-free welds with predictable microstructural and mechanical characteristics, making the process suitable for underwater repair and fabrication applications. Research limitations/implications The experiments were conducted in a water environment using an acrylic water tank. This system does not fully simulate marine environmental conditions, including salinity, turbulence, waves or varying hydrostatic pressure. The study is a bead-on-plate investigation, in which tensile, bend, impact, fatigue and fracture-toughness tests cannot be performed on representative joints, so no conclusion on toughness or structural integrity is drawn; and only visual, macrographic and microscopic inspection was used, so claims of soundness refer to the absence of visible defects only. Originality/value This is first such work where GMAW is used with localised cavity. Usage of this type of localised cavity has been very rarely found for some other welding processes like flux cored arc welding and laser welding. But work related to local dry underwater welding on gas metal arc welding has not been published in the available literature.
Authors
- Pankaj Biswas (ORCID: https://orcid.org/0000-0001-7069-0308)
- Himangshu Kalita
- Indrajeet Singh Yadav
- Aditya Sharma
Institutions
- Indian Institute of Technology Guwahati (IN)
Publication Details
- Journal
- International Journal of Intelligent Unmanned Systems
- Published
- 2026-11-20
- DOI
- https://doi.org/10.1108/ijius-05-2026-0204
- Primary Topic
- Welding Techniques and Residual Stresses
- Type
- article
- Field-Weighted Citation Impact
- 0.00