Effect of Non-Pneumatic Wheel Design and Z-Stiffness on the Rollability of a Wheeled Chassis
This study compares wheel designs and their measured Z-stiffness in relation to the rollability of a wheeled chassis equipped with a fixed profile mesh. Three compliant non-pneumatic wheels with identical nominal printed outer dimensions were designed to provide different structural responses and fabricated using TPU 85A through fused deposition modeling. Each wheel configuration was evaluated under 20 combinations of launch height, horizontal speed, and angle using a pneumatic launcher, with five launches per combination; a Mecanum wheel configuration served as the baseline. A condition was classified as successful when at least three of its five launches ended in a stable on-the-wheels configuration. Among the compliant designs, the wheel with the highest measured secant stiffness achieved the highest proportion of successful conditions (Wheel 3, 55%), followed by Wheel 2 (45%) and the wheel with the lowest measured secant stiffness (Wheel 1, 25%); the baseline achieved 75%. Wheel mass, estimated rotational inertia, deformation mode, and contact behavior also vary with design. The results therefore demonstrate an association between wheel design, compression stiffness, and recovery success in the tested conditions, while the independent effect of stiffness remains unresolved.
Authors
- Meysam Khaleghian
- Farshad Jabari
Institutions
- Texas State University (US)
Publication Details
- Journal
- Machines
- Published
- 2026-11-18
- DOI
- https://doi.org/10.3390/machines14111368
- Primary Topic
- Soil Mechanics and Vehicle Dynamics
- Type
- article
- Field-Weighted Citation Impact
- 0.00