Parametric Finite Element Investigation of the Effects of Re-entrant Angle and Wall Thickness on the Compressive Behavior of Auxetic Cellular Structures
The objective of this research is to analyze the impact of re-entrant angle and wall thickness on compressive properties of auxetic cellular materials. Six 3D models were built combining three different re-entrant angles (50°, 60°, and 70°) with two different wall thicknesses (0.7 and 1.0 mm). The models were analyzed in ANSYS software under the same conditions with imposed compressive displacement 0.25 mm. From the results, it can be observed that the compressive stiffness increased with the increase of re-entrant angle and wall thickness. In the 50° configuration, the lowest compressive stiffness was found to be 70.14 N/mm when the wall thickness was 0.7 mm while in the 70° configuration, the highest compressive stiffness was recorded at 258.06 N/mm when the wall thickness was 1.0 mm. With the increase in wall thickness from 0.7 mm to 1.0 mm, the compressive stiffness improved by about 180.2%, 90.6%, and 4.7% in 50°, 60°, and 70° angles, respectively. The maximum equivalent stress was between 2.13 MPa and 4.88 MPa. From the results, it can be concluded that the effect of wall thickness on compressive stiffness is highly dependent on the re-entrant angle.
Authors
- Raheem Dohan Owayez (ORCID: https://orcid.org/0000-0002-4784-7220)
Institutions
- University of Al-Qadisiyah (IQ)
Publication Details
- Journal
- American Journal of Engineering Mechanics and Architecture (2993-2637)
- Published
- 2026-11-17
- DOI
- https://doi.org/10.31150/d9tht921
- Primary Topic
- Cellular and Composite Structures
- Type
- article
- Field-Weighted Citation Impact
- 0.00