Interfacial reactions and properties of tungsten–silicon nitride composites prepared by spark plasma sintering
Tungsten–silicon nitride (W/Si₃N₄) composite ceramics were prepared by spark plasma sintering (SPS) at 1650–1800 °C with W contents of 0–20 vol%. The effects of processing on interfacial reactions, microstructure and properties were examined by X-ray diffraction, microscopy and property measurements. W₅Si₃ was detected in the specimens sintered at 1650 and 1800 °C, while its peaks were not resolved at 1700–1750 °C. A change in local nitrogen transport during densification is proposed as a possible explanation for this temperature dependence. In the WSN20 specimen sintered at 1750 °C, atomic-resolution TEM revealed a local W/Y₂O₃ contact. The two reported lattice spacings differed by approximately 1.29% in one dimension. This interfacial structure is considered alongside the measured mechanical properties and thermal conductivity. The observations identify a temperature-dependent phase response and an oxide-derived metal/ceramic interface for further investigation; the effects of local nitrogen pressure and interfacial bonding on bulk properties remain to be established.
Authors
- Yu Zhou (ORCID: https://orcid.org/0000-0003-4692-0438)
- Yunzhu Ma
- Wensheng Liu
Institutions
- Central South University (CN)
- Powder Metallurgy Institute (BY)
Publication Details
- Journal
- Journal of Advanced Ceramics
- Published
- 2026-11-18
- DOI
- https://doi.org/10.26599/jac.2026.9221413
- Primary Topic
- Advanced ceramic materials synthesis
- Type
- article
- Field-Weighted Citation Impact
- 0.00