Low-Cost MEMS IMU Velocity Estimation Using Physics-Guided LSTM Residual Correction
Velocity estimation with low-cost MEMS inertial measurement units (IMUs) is difficult because accelerometer bias, gravity-projection error, vibration, and integration drift accumulate rapidly. This paper presents a physics-guided residual-learning velocity estimator. A direction-cosine-matrix complementary filter removes gravity, an FFT-guided moving average aligned to the dominant vibration period suppresses vibration, and direct integration yields a preliminary velocity. A two-layer long short-term memory (LSTM) network then predicts only the residual error of this velocity from IMU-derived features, rather than regressing velocity directly. At inference, no zero-velocity update, Kalman filter, or external positioning is used. Weights are learned from straight-line motion only; curved-path validation trials serve solely for early stopping and hyperparameter tuning. Evaluation on a wheeled robot with an RTK-GPS reference covers ten trials at each of three unseen speeds over straight, circular, and stadium-shaped trajectories. The estimator achieves RMSE ≤ 0.0307 m/s and R2 ≥ 0.9872. Compared with an encoder-referenced multi-filter baseline, it significantly reduces RMSE in all conditions, reduces bias by two to ten times, and cuts cumulative-distance error by 52% on average without the encoder. Compared with an LSTM regressing velocity directly from the same features, it reduces RMSE by up to ten times, confirming the benefit of residual learning.
Authors
- Wooseong Che
- Yan Linn Aung (ORCID: https://orcid.org/0000-0002-4319-5261)
Institutions
- Kyungsung University (KR)
Publication Details
- Published
- 2026-11-18
- DOI
- https://doi.org/10.3390/robots1010001
- Primary Topic
- Inertial Sensor and Navigation
- Type
- article
- Field-Weighted Citation Impact
- 0.00