NO x Emission Characteristics During Air-Staged Fluidized–Melting Combustion of Coal Gasification Fine Slag

Low-volatile, high-ash fuels are characterized by delayed ignition and slow char oxidation, while their high mineral content can further restrict oxygen transport and carbon burnout. Fluidized–melting combustion can intensify carbon conversion and simultaneously recover the mineral fraction as molten slag, but the high-temperature, oxygen-enriched environment may promote NOx formation. In this study, coal gasification fine slag (CGFS) was used as a representative low-volatile, high-ash fuel to investigate air-staging strategies in a 100 t/a fluidized–melting system. Conventional staging strategies within the high-temperature region were compared with a strategy that transferred part of the oxygen supply to a lower-temperature downstream region. Moving the tertiary-air injection position from 400 to 1200 mm increased NOx emissions from 617.23 to 850.04 mg/Nm3, despite extending the geometric reduction zone. Increasing the tertiary-air fraction from 12.5% to 100% also increased NOx emissions from 573.76 to 906.35 mg/Nm3, while the apparent fuel-N release fraction changed only slightly. In contrast, increasing the overfire-air fraction to 37.5% reduced NOx emissions by 42.85%, from 573.76 to 327.89 mg/Nm3 and decreased the NOx-N emission index from 20.47% to 6.20%. This improvement was accompanied by an increase in solid-phase nitrogen retention and a decrease in combustion efficiency from 94.95% to 92.16%. These results suggest that NOx control may depend on the overlap between fuel-N conversion and high-temperature oxygen supply in addition to geometric staging. Distributing oxygen according to temperature level therefore provides a potential route for balancing NOx emissions and carbon burnout for the tested CGFS. NOx concentrations are reported on a dry basis and corrected to 9% O2. Nitrogen partitioning is apparent, as N2 was not directly measured and nitrogen-containing intermediates remained below the detection limit.

Authors

Institutions

Publication Details

Journal
Combustion Science and Technology
Published
2026-11-17
DOI
https://doi.org/10.1080/00102202.2026.2765489
Primary Topic
Coal Combustion and Slurry Processing
Type
article
Field-Weighted Citation Impact
0.00
Controls
|||
ALL TIME
JAN
FEB
MAR
APR
MAY
JUN
JUL
AUG
SEP
OCT
NOV
article

NO x Emission Characteristics During Air-Staged Fluidized–Melting Combustion of Coal Gasification Fine Slag

Qiangqiang Ren, Shilong Dong, Chen Liang, Wei Li et al.
Combustion Science and Technology
Coal Combustion and Slurry Processing
article

NO x Emission Characteristics During Air-Staged Fluidized–Melting Combustion of Coal Gasification Fine Slag

Qiangqiang Ren, Shilong Dong, Chen Liang, Wei Li, Bowen Zhang, Wenyu Wang, Shuai Guo, Zhiyong Chen
article en

Abstract

Low-volatile, high-ash fuels are characterized by delayed ignition and slow char oxidation, while their high mineral content can further restrict oxygen transport and carbon burnout. Fluidized–melting combustion can intensify carbon conversion and simultaneously recover the mineral fraction as molten slag, but the high-temperature, oxygen-enriched environment may promote NOx formation. In this study, coal gasification fine slag (CGFS) was used as a representative low-volatile, high-ash fuel to investigate air-staging strategies in a 100 t/a fluidized–melting system. Conventional staging strategies within the high-temperature region were compared with a strategy that transferred part of the oxygen supply to a lower-temperature downstream region. Moving the tertiary-air injection position from 400 to 1200 mm increased NOx emissions from 617.23 to 850.04 mg/Nm3, despite extending the geometric reduction zone. Increasing the tertiary-air fraction from 12.5% to 100% also increased NOx emissions from 573.76 to 906.35 mg/Nm3, while the apparent fuel-N release fraction changed only slightly. In contrast, increasing the overfire-air fraction to 37.5% reduced NOx emissions by 42.85%, from 573.76 to 327.89 mg/Nm3 and decreased the NOx-N emission index from 20.47% to 6.20%. This improvement was accompanied by an increase in solid-phase nitrogen retention and a decrease in combustion efficiency from 94.95% to 92.16%. These results suggest that NOx control may depend on the overlap between fuel-N conversion and high-temperature oxygen supply in addition to geometric staging. Distributing oxygen according to temperature level therefore provides a potential route for balancing NOx emissions and carbon burnout for the tested CGFS. NOx concentrations are reported on a dry basis and corrected to 9% O2. Nitrogen partitioning is apparent, as N2 was not directly measured and nitrogen-containing intermediates remained below the detection limit.

Combustion Science and Technology
Chinese Academy of Sciences (CN), University of Chinese Academy of Sciences (CN)
Coal Combustion and Slurry Processing
AI Navigator

Ask Laika to Summarize, Analyze, and Connect papers live on the map.

Summarize Papers & Methodologies

Extract key findings, datasets, and comparative methods across publications.

Benchmark Rankings & Visual Analytics

Rank top research institutions, authors, funders, topics, and journals by Field-Weighted Citation Impact (FWCI) and paper volume with instant charts.

Connect Distant Disciplines

Bridge topological clusters on the map to find hidden collaborative intersections.

Laika access coming soon