Tandem Architecture of Luminescent Solar Concentrator Based on AgInS 2 /ZnS Quantum Dots for Maximizing Light Harvesting

ABSTRACT Luminescent solar concentrators (LSCs) offer a promising solution for building‐integrated photovoltaics by combining large‐area light collection with edge‐mounted solar cells. To date, their widespread adoption has been limited by three fundamental challenges: (1) reabsorption losses in fluorescent materials, (2) incomplete solar spectrum coverage, and (3) the use of environmentally harmful fluorophores, for example, toxic heavy‐metal‐based quantum dots (QDs). Here, we present a tandem heavy‐metal‐free QD‐LSC architecture based on composition‐tuned AgInS 2 /ZnS QDs that simultaneously addresses these limitations. Our design features three vertically stacked layers with distinct Ag:In ratios (1:2, 1:1, and 1:0.5) to achieve broadband solar spectrum harvesting from visible to near‐infrared wavelengths (up to ∼700 nm). The optimized core–shell QDs exhibit high photoluminescence quantum yields (up to 50%) and large Stokes shifts, significantly reducing reabsorption losses. As an upper‐bound estimate of the total light output, the sum of currents measured separately from each layer in the stack is 12.61 mA. When measured as a complete three‐layer stack using a single photovoltaic (PV) strip covering the full edge (5 cm × 0.6 cm, J sc = 30 mA cm −2 , the geometric gain factor G = 8.33), the tandem LSC delivers an output current of 10.58 mA from a single edge, which is a 67% enhancement over the best single‐layer device (6.35 mA, measured at G = 25 with a 5 cm × 0.2 cm PV strip). This corresponds to a measured single‐edge optical efficiency of 1.41% at G = 8.33. Assuming symmetric light output from all four edges, the projected four‐edge efficiency is 5.64%. The projected four‐edge optical efficiencies of the top, middle, and bottom layers are 1.69%, 2.58%, and 2.04%, respectively. Furthermore, the top‐layer QDs provide a protective effect against UV‐induced degradation, maintaining 74%−78% of the initial PL intensity after 5 h of UV exposure (365 nm, 10 mW cm −2 , in air). These results demonstrate that the tandem architecture based on heavy‐metal‐free AgInS 2 /ZnS QDs offers a promising route toward efficient, stable, and environmentally benign LSCs for building‐integrated photovoltaics.

Authors

Institutions

Publication Details

Journal
SmartSys
Published
2026-11-17
DOI
https://doi.org/10.1002/sys3.70051
Primary Topic
Photochemistry and Electron Transfer Studies
Type
article
Field-Weighted Citation Impact
0.00
Controls
|||
ALL TIME
JAN
FEB
MAR
APR
MAY
JUN
JUL
AUG
SEP
OCT
NOV
article

Tandem Architecture of Luminescent Solar Concentrator Based on AgInS 2 /ZnS Quantum Dots for Maximizing Light Harvesting

Gurpreet Singh Selopal, Federico Rosei, Lei Jin, Xin Liu
SmartSys
Photochemistry and Electron Transfer Studies
article

Tandem Architecture of Luminescent Solar Concentrator Based on AgInS 2 /ZnS Quantum Dots for Maximizing Light Harvesting

Gurpreet Singh Selopal, Federico Rosei, Lei Jin, Xin Liu
article en

Abstract

ABSTRACT Luminescent solar concentrators (LSCs) offer a promising solution for building‐integrated photovoltaics by combining large‐area light collection with edge‐mounted solar cells. To date, their widespread adoption has been limited by three fundamental challenges: (1) reabsorption losses in fluorescent materials, (2) incomplete solar spectrum coverage, and (3) the use of environmentally harmful fluorophores, for example, toxic heavy‐metal‐based quantum dots (QDs). Here, we present a tandem heavy‐metal‐free QD‐LSC architecture based on composition‐tuned AgInS 2 /ZnS QDs that simultaneously addresses these limitations. Our design features three vertically stacked layers with distinct Ag:In ratios (1:2, 1:1, and 1:0.5) to achieve broadband solar spectrum harvesting from visible to near‐infrared wavelengths (up to ∼700 nm). The optimized core–shell QDs exhibit high photoluminescence quantum yields (up to 50%) and large Stokes shifts, significantly reducing reabsorption losses. As an upper‐bound estimate of the total light output, the sum of currents measured separately from each layer in the stack is 12.61 mA. When measured as a complete three‐layer stack using a single photovoltaic (PV) strip covering the full edge (5 cm × 0.6 cm, J sc = 30 mA cm −2 , the geometric gain factor G = 8.33), the tandem LSC delivers an output current of 10.58 mA from a single edge, which is a 67% enhancement over the best single‐layer device (6.35 mA, measured at G = 25 with a 5 cm × 0.2 cm PV strip). This corresponds to a measured single‐edge optical efficiency of 1.41% at G = 8.33. Assuming symmetric light output from all four edges, the projected four‐edge efficiency is 5.64%. The projected four‐edge optical efficiencies of the top, middle, and bottom layers are 1.69%, 2.58%, and 2.04%, respectively. Furthermore, the top‐layer QDs provide a protective effect against UV‐induced degradation, maintaining 74%−78% of the initial PL intensity after 5 h of UV exposure (365 nm, 10 mW cm −2 , in air). These results demonstrate that the tandem architecture based on heavy‐metal‐free AgInS 2 /ZnS QDs offers a promising route toward efficient, stable, and environmentally benign LSCs for building‐integrated photovoltaics.

SmartSysVol. 2(4)
Dalhousie University (CA), University of Trieste (IT), Southern University of Science and Technology (CN), Institut National de la Recherche Scientifique (CA)
Photochemistry and Electron Transfer Studies
AI Navigator

Ask Laika to Summarize, Analyze, and Connect papers live on the map.

Summarize Papers & Methodologies

Extract key findings, datasets, and comparative methods across publications.

Benchmark Rankings & Visual Analytics

Rank top research institutions, authors, funders, topics, and journals by Field-Weighted Citation Impact (FWCI) and paper volume with instant charts.

Connect Distant Disciplines

Bridge topological clusters on the map to find hidden collaborative intersections.

Laika access coming soon