Optimization of Copper Electroplating Parameters for SLA-Printed EDM Electrodes
Stereolithography (SLA) 3D printing offers high dimensional accuracy and design flexibility, making it suitable for fabricating complex Electrical Discharge Machining (EDM) electrodes. However, the non-conductive nature of SLA-printed resin limits its direct application in EDM processes. This study investigates the feasibility of producing conductive EDM electrodes by integrating SLA 3D printing with copper electroplating. Cylindrical electrodes were fabricated using high-temperature SLA resin and subsequently metallized using a conductive coating to enable electroplating. Copper electroplating was carried out using a copper sulphate–sulphuric acid electrolyte, with a fixed copper sulphate content of 55 g per 250 ml of solution. Sulphuric acid concentration, applied current, and plating time were selected as the main process parameters. Sulphuric acid concentrations of 11 ml, 14.5 ml, and 18 ml per 250 ml solution were investigated, along with current values of 0.06 A, 0.09 A, and 0.11 A, and plating durations of 3, 6, and 9 hours. Electrical resistance and coating thickness were measured as the primary response variables. A Design of Experiment (DOE) approach was employed to evaluate the influence of electroplating parameters on electrical resistance. Analysis of Variance (ANOVA) results indicated that plating time had the most significant effect on electrical resistance, while sulphuric acid concentration and current showed less pronounced influence within the tested range. A quadratic model was selected as the most suitable representation of the experimental data due to its acceptable fit and absence of significant lack of fit, although its predictive capability was limited. The optimized parameter combination suggested by the model consisted of 14.5 ml sulphuric acid per 250 ml solution, a current of 0.085 A, and a plating time of 6 hours. Overall, the results demonstrate that copper electroplating effectively enhances the electrical resistance of SLA-printed electrodes, highlighting their potential as cost-effective alternatives to conventionally manufactured EDM electrodes through a hybrid manufacturing approach.
Authors
- Reazul Haq Abdul Haq (ORCID: https://orcid.org/0000-0001-8186-6751)
- Sharifah Adzila (ORCID: https://orcid.org/0000-0001-7082-5866)
- Bukhari Manshoor (ORCID: https://orcid.org/0000-0002-3868-0211)
- Said Ahmad (ORCID: https://orcid.org/0000-0001-7002-2617)
- Mohammad Fahmi Abdul Ghafir (ORCID: https://orcid.org/0000-0001-8988-1171)
- Shahrul Nizam Abdul Rahman
- Yashvir Singh
- Sanusi Sanusi
Institutions
- Harcourt Butler Technical University (IN)
- Ibn Sina Hospital (KW)
- Tun Hussein Onn University of Malaysia (MY)
Publication Details
- Journal
- Diffusion and defect data, solid state data. Part B, Solid state phenomena/Solid state phenomena
- Published
- 2026-11-18
- DOI
- https://doi.org/10.4028/p-wrd3ku
- Primary Topic
- Electrodeposition and Electroless Coatings
- Type
- article
- Field-Weighted Citation Impact
- 0.00