Thermal–Hydraulic Performance of a Shell-and-Tube Heat Exchanger Using Oil-Based Nanofluids: A Two-Phase CFD Modeling Approach
Nanofluids are promising for improving heat transfer in oil-based thermal systems, but their predicted behavior in shell-and-tube heat exchangers depends on how particles and base fluid are represented numerically. This study evaluates the thermal-hydraulic performance of oil-based nanofluids using single-phase (SP) and two-phase (TP) CFD formulations. Both models were validated against published experimental data for Al₂O₃/water nanofluids and reproduced the measured trends, with mean absolute percentage errors of 7.14% to 15.02% for TP and 9.37% to 16.47% for SP. Cu, CuO, and TiO₂ nanoparticles dispersed in Therminol LT were then examined at volume fractions of 1, 2, 3, 5, and 6%. SP predicted overall heat transfer coefficients up to about 9.5% higher than TP. For Cu nanofluids, the maximum improvement over pure oil was about 10.7% with SP and about 3.8% with TP, while pressure drop was nearly identical for both. TP results showed very low slip velocities, indicating strong phase coupling and negligible particle redistribution. The thermal differences are attributed mainly to phase representation and local thermophysical-property treatment. Cu performed best, followed by CuO and TiO₂. The optimum concentration was about 5 vol.% with SP and about 3 vol.% with TP. The formulation strongly influenced predicted heat transfer and optimum concentration, but had limited effect on pressure drop and particle ranking. .
Authors
- Ahmed Mohsen Hafez (ORCID: https://orcid.org/0000-0003-0051-1911)
- Mahmoud Fouad
- Ahmed Abu-Zaid
- Mohamed Rashad Ali (ORCID: https://orcid.org/0009-0009-3948-5678)
Institutions
- Cairo University (EG)
Publication Details
- Journal
- Research Square
- Published
- 2026-11-18
- DOI
- https://doi.org/10.21203/rs.3.rs-11569409/v1
- Primary Topic
- Nanofluid Flow and Heat Transfer
- Type
- preprint