Multi-performance optimization of CO2-MQL burnishing process considering surface properties
In this work, process parameters of the CO 2 -based minimum quantity lubrication burnishing (CMB) process, including the spindle speed ( S ), feed rate ( f ), and penetration depth ( D ) are optimized to maximize the Vickers hardness ( VH ) and reduce the maximum height roughness in the defined area ( Sz ). A set of CMB experiments was conducted on SKD61 steel. The Gaussian process regression (GPR) and ensembles of trees (ET) approaches were used to propose predictive models of the CMB responses. The criteria importance through intercriteria correlation (CRITIC), elite-guided adaptive Cauchy-zebra optimization algorithm (ECZOA), and multi-attributive ideal-real comparative analysis (MAIRCA) are utilized to compute the weights, generate feasible solutions, and determine the best point. The findings showed that the optimal S , f , and D were 1600 rpm, 100 mm/min, and 0.20 mm, respectively. At the optimal point, the improvements in the VH and Sz were 5.5% and 30.0%, respectively. Moreover, the average coefficient of friction ( COF ) and final wear depth ( Z ) were reduced from approximately 0.704 to 0.581 and from 0.17 to 0.08 mm, respectively, demonstrating the improved tribological performance of the optimized CMB process. The GPR approach outperformed the ET model in predicting the CMB responses. The integrated GPR-ECZOA-MAIRCA procedure successfully identified a beneficial operating condition for simultaneously improving Sz and VH within the investigated parameter domain. Microstructural observations revealed that higher S and D promoted more extensive subsurface deformation. The compressive residual stress (CRS) of − 412.48 MPa was obtained, demonstrating the development of substantial compressive stresses and improved surface integrity in the burnished SKD61 steel.
Authors
- Huu-Toan Bui
- Trung-Thanh Nguyen
- An-Le Van
Institutions
- Le Quy Don Technical University (VN)
- Trường ĐH Nguyễn Tất Thành (VN)
Publication Details
- Journal
- Scientific Reports
- Published
- 2026-11-18
- DOI
- https://doi.org/10.1038/s41598-026-80994-0
- Primary Topic
- Advanced machining processes and optimization
- Type
- article
- Field-Weighted Citation Impact
- 0.00
Funders
- National Foundation for Science and Technology Development
- Trường Đại học Nguyễn Tất Thành
- Le Quy Don Technical University