Cyclic Response of Concrete Columns Reinforced with Quantum Tech–Produced 600-Grade Bars

High-strength rebar (HSR) may enhance the strength and stiffness of concrete columns while minimizing rebar usage and congestion, hence reducing CO 2 emissions and improving construction quality; however, their seismic performance remains under investigation. This study investigates the seismic response of full-scale RC columns reinforced with 600 grade (a nominal yield strength of 600 MPa and over) HSR under quasi-static reversed cyclic loads. To determine the hysteretic behavior of HSR-reinforced concrete columns, seven full-scale specimens were prepared, cured, and tested under combined axial and cyclic loads until complete failure. The varying parameters of HSR-reinforced columns are reinforcement ratio, concrete grades, and rebar diameters. Hysteresis loops and skeleton curves obtained from test results at different key stages, such as yielding, peak, and ultimate capacity, crack propagation, failure mechanism, and bar buckling, were analyzed and compared with those of the normal-strength (500 MPa) reinforced columns. Various parameters related to the cyclic capacity of HSR columns, such as energy dissipation, equivalent viscous damping, and stiffness degradation, were also analyzed explicitly. HSR-reinforced columns (HSRC) showed an improved performance in terms of increased strength, stiffness, ductility, and energy dissipation compared with that of the normal-strength rebar (NSR)-reinforced column (NSRC). For example, for 30-MPa concrete, HSRC showed 7% higher ultimate load than that of the NSRC, where other parameters remained the same. Similar observations were found for the 40-MPa concrete, where a maximum load of 59.55 kN was recorded, outperforming the NSRC specimen and indicating that using a higher-grade concrete with HSR will significantly increase the capacity of the columns. Experimental results also revealed that rebar diameter and elongation are significantly correlated to the seismic drift capacity of the columns, with smaller diameters showing a lower drift ratio capacity, possibly due to the premature rebar buckling, which was observed to happen up to a diameter of 16 mm regardless of rebar strength. Furthermore, the analytical estimation of drift ratios corresponding to the bar-buckling limit state of the HSRCs requires the revision of existing analytical models.

Authors

Institutions

Publication Details

Journal
Journal of structural design and construction practice.
Published
2026-11-18
DOI
https://doi.org/10.1061/jsdccc.sceng-2175
Primary Topic
Structural Behavior of Reinforced Concrete
Type
article
Field-Weighted Citation Impact
0.00
Controls
|||
ALL TIME
JAN
FEB
MAR
APR
MAY
JUN
JUL
AUG
SEP
OCT
NOV
article

Cyclic Response of Concrete Columns Reinforced with Quantum Tech–Produced 600-Grade Bars

Raquib Ahsan, Khondaker Sakil Ahmed, Md Ziaul Hasan, Abdullah Al Moneim et al.
Journal of structural design and construction practice.
Structural Behavior of Reinforced Concrete
article

Cyclic Response of Concrete Columns Reinforced with Quantum Tech–Produced 600-Grade Bars

Raquib Ahsan, Khondaker Sakil Ahmed, Md Ziaul Hasan, Abdullah Al Moneim, Saiful Islam
article en

Abstract

High-strength rebar (HSR) may enhance the strength and stiffness of concrete columns while minimizing rebar usage and congestion, hence reducing CO 2 emissions and improving construction quality; however, their seismic performance remains under investigation. This study investigates the seismic response of full-scale RC columns reinforced with 600 grade (a nominal yield strength of 600 MPa and over) HSR under quasi-static reversed cyclic loads. To determine the hysteretic behavior of HSR-reinforced concrete columns, seven full-scale specimens were prepared, cured, and tested under combined axial and cyclic loads until complete failure. The varying parameters of HSR-reinforced columns are reinforcement ratio, concrete grades, and rebar diameters. Hysteresis loops and skeleton curves obtained from test results at different key stages, such as yielding, peak, and ultimate capacity, crack propagation, failure mechanism, and bar buckling, were analyzed and compared with those of the normal-strength (500 MPa) reinforced columns. Various parameters related to the cyclic capacity of HSR columns, such as energy dissipation, equivalent viscous damping, and stiffness degradation, were also analyzed explicitly. HSR-reinforced columns (HSRC) showed an improved performance in terms of increased strength, stiffness, ductility, and energy dissipation compared with that of the normal-strength rebar (NSR)-reinforced column (NSRC). For example, for 30-MPa concrete, HSRC showed 7% higher ultimate load than that of the NSRC, where other parameters remained the same. Similar observations were found for the 40-MPa concrete, where a maximum load of 59.55 kN was recorded, outperforming the NSRC specimen and indicating that using a higher-grade concrete with HSR will significantly increase the capacity of the columns. Experimental results also revealed that rebar diameter and elongation are significantly correlated to the seismic drift capacity of the columns, with smaller diameters showing a lower drift ratio capacity, possibly due to the premature rebar buckling, which was observed to happen up to a diameter of 16 mm regardless of rebar strength. Furthermore, the analytical estimation of drift ratios corresponding to the bar-buckling limit state of the HSRCs requires the revision of existing analytical models.

Journal of structural design and construction practice.Vol. 32(2)
Bangladesh University of Engineering and Technology (BD), Military Institute of Science and Technology (BD)
Industry, innovation and infrastructure
Structural Behavior of Reinforced Concrete
AI Navigator

Ask Laika to Summarize, Analyze, and Connect papers live on the map.

Summarize Papers & Methodologies

Extract key findings, datasets, and comparative methods across publications.

Benchmark Rankings & Visual Analytics

Rank top research institutions, authors, funders, topics, and journals by Field-Weighted Citation Impact (FWCI) and paper volume with instant charts.

Connect Distant Disciplines

Bridge topological clusters on the map to find hidden collaborative intersections.

Laika access coming soon