A Comprehensive Database-Driven Analysis of Size Effect on Shear Strength of Reinforced Concrete Beams Without Stirrups: From Statistical Biases to Advanced Predictive Modelling
In the current paper, an investigation into the influence of the size effect on the shear strength of unreinforced concrete beams using a data-driven approach including statistical analysis, calibration, and prediction is carried out. The database consists of 804 test results collected from 41 sources and covers a wide range of effective depths (44–1670 mm), reinforcement ratios (0.26–15.23%) and shear span-to-depth ratios (0.39–9.76). The dependent variable was carefully validated and recalculated based on the maximum load to avoid transcription mistakes. As a result of the statistical analysis, biases and correlations were found between the effective depth and the reinforcement ratio, which lead to misinterpretation of the size effect in the univariate case. The calibration of Bazant’s Size Effect Law proved that the transitional size parameter (d0) varies from 90.1 mm to 1000 mm depending on the reinforcement ratio. To make a fair comparison of nominal to nominal, the formulation of ACI 318-19 included the size effect factor λ, while the partial safety factor γc was not included in Eurocode 2. It was found that both the codes are extremely conservative, with percentage bias (PBIAS) of −45.9% in the case of ACI, and −26.8% in the case of EC2. The suggested GPR model has yielded a very high R2 value of 0.713 and near- zero aggregate bias (PBIAS = −4.4%). With the help of statistical tests such as the Wilcoxon signed-rank test, it was proved that the GPR performs significantly better than ACI (p = 6.37 × 10−21) and Eurocode 2 (p = 4.95 × 10−7). Even though GPR under-predicts on aggregate (conservative), it offers a good 95% prediction interval (coverage of 90.6%). Thus, a safety factor of 1.05 is suggested. The results from a sensitivity analysis based on the random forest feature importance revealed that the most sensitive parameters are the a/d ratio and the a/d ratio by the size factor (kd), which contribute 24.1% and 12.2% to the total variance, respectively. The proposed approach will be very helpful in designing shear safely and economically.
Authors
- Hesham Salim Al-Rawe (ORCID: https://orcid.org/0000-0002-3765-5137)
- Asaad Almssad (ORCID: https://orcid.org/0000-0002-4536-9747)
- Majid Al‐Gburi (ORCID: https://orcid.org/0000-0002-9987-0174)
- A. A. Alhayani (ORCID: https://orcid.org/0009-0000-6550-6158)
Institutions
- Northern Technical University (IQ)
- Karlstad University (SE)
Publication Details
- Journal
- Buildings
- Published
- 2026-11-17
- DOI
- https://doi.org/10.3390/buildings16224585
- Primary Topic
- Structural Behavior of Reinforced Concrete
- Type
- article
- Field-Weighted Citation Impact
- 0.00