Development and performance analysis of bio-based composite materials using Cynara scolymus cellulose fibers: Experimental study

This study investigates the development and performance of bio-based composite materials reinforced with cellulose fibers extracted from Cynara scolymus (artichoke) stems, addressing the scientific gap regarding the influence of fiber length on the mechanical and hygroscopic properties of epoxy biocomposites. To make test specimens, the fibers were removed through the water retting method, followed by cutting them into three lengths (0.5, 1 and 1.5 cm) and embedded into an epoxy matrix at a 10% volume fraction. Tensile and flexural tests and the absorption of moisture in different aqueous conditions and the microstructure were used in describing the composites through optical microscopy and SEM. These findings revealed that the critical parameter that determines performance is fiber length: the 1.5 cm reinforcement delivered the highest tensile strength (32 MPa, which is 45% higher than that of 0.5 cm samples) and ductile behavior (3.5% deformation) and the 1 mm fibers delivered the best flexural strength (18 Mpa). The maximum moisture absorption was with 1.5 cm fiber composites (1.8% in fresh water) and minimum in 0.5 cm samples (1.2% in seawater). The microstructural analysis proved that the dispersion was homogeneous, however, it also showed that the interfaces were limited by means of fiber pull-out and micro voids. It is concluded that Cynara scolymus fibers are promising in terms of use as renewable reinforcements, but the performance highly depends on the choice of fiber length and that to reach similar mechanical properties with literature values; attention on interfacial adhesion via fiber treatment or favorable processing is required.

Authors

Institutions

Publication Details

Journal
Journal of Composite Materials
Published
2026-11-17
DOI
https://doi.org/10.1177/00219983261505784
Primary Topic
Natural Fiber Reinforced Composites
Type
article
Field-Weighted Citation Impact
0.00

Funders

Controls
|||
ALL TIME
JAN
FEB
MAR
APR
MAY
JUN
JUL
AUG
SEP
OCT
NOV
article

Development and performance analysis of bio-based composite materials using Cynara scolymus cellulose fibers: Experimental study

Hasna Bouhali, Ibrahim Mahariq, Mohamed Kezzar, Mohamed Rafik Sari et al.
4 links
Journal of Composite Materials
Natural Fiber Reinforced Composites
article

Development and performance analysis of bio-based composite materials using Cynara scolymus cellulose fibers: Experimental study

Hasna Bouhali, Ibrahim Mahariq, Mohamed Kezzar, Mohamed Rafik Sari, Ramy M. Hafez, Mohamed Said Kahaleras, Nabil Talbi, Hazzaa F. Alqurashi, Farhan Lafta Rashid, Ilyas Khan
article en

Abstract

This study investigates the development and performance of bio-based composite materials reinforced with cellulose fibers extracted from Cynara scolymus (artichoke) stems, addressing the scientific gap regarding the influence of fiber length on the mechanical and hygroscopic properties of epoxy biocomposites. To make test specimens, the fibers were removed through the water retting method, followed by cutting them into three lengths (0.5, 1 and 1.5 cm) and embedded into an epoxy matrix at a 10% volume fraction. Tensile and flexural tests and the absorption of moisture in different aqueous conditions and the microstructure were used in describing the composites through optical microscopy and SEM. These findings revealed that the critical parameter that determines performance is fiber length: the 1.5 cm reinforcement delivered the highest tensile strength (32 MPa, which is 45% higher than that of 0.5 cm samples) and ductile behavior (3.5% deformation) and the 1 mm fibers delivered the best flexural strength (18 Mpa). The maximum moisture absorption was with 1.5 cm fiber composites (1.8% in fresh water) and minimum in 0.5 cm samples (1.2% in seawater). The microstructural analysis proved that the dispersion was homogeneous, however, it also showed that the interfaces were limited by means of fiber pull-out and micro voids. It is concluded that Cynara scolymus fibers are promising in terms of use as renewable reinforcements, but the performance highly depends on the choice of fiber length and that to reach similar mechanical properties with literature values; attention on interfacial adhesion via fiber treatment or favorable processing is required.

Journal of Composite Materials
Al-Ahliyya Amman University (JO), Badji Mokhtar-Annaba University (DZ), China Medical University (TW), Majmaah University (SA), Korea University (KR), Umm al-Qura University (SA), Al-Quds University (PS), Imam Mohammad ibn Saud Islamic University (SA), İstanbul Gelişim Üniversitesi (TR), University of Kerbala (IQ), University of Kyrenia (CY), National Higher School of Technology and Engineering Annaba (DZ), Near East University (CY), Széchenyi István University (HU), Saveetha University (IN), China Medical University (CN), University of Skikda (DZ)
Umm Al-Qura University
Natural Fiber Reinforced Composites
AI Navigator

Ask Laika to Summarize, Analyze, and Connect papers live on the map.

Summarize Papers & Methodologies

Extract key findings, datasets, and comparative methods across publications.

Benchmark Rankings & Visual Analytics

Rank top research institutions, authors, funders, topics, and journals by Field-Weighted Citation Impact (FWCI) and paper volume with instant charts.

Connect Distant Disciplines

Bridge topological clusters on the map to find hidden collaborative intersections.

Laika access coming soon