Distortion Behavior of Ti6Al4V and Inconel 718 LPBF Cantilever Specimens: Effects of Scan Strategy and Stress-Relief Heat Treatment
Residual stresses and the resulting distortion remain major challenges in achieving high dimensional accuracy in laser beam powder bed fusion (PBF-LB) components. This study experimentally investigates the distortion behavior of PBF-LB cantilever specimens fabricated from IN718 and Ti6Al4V, with particular emphasis on the effects of scan strategy and stress-relief heat treatment. Three hatch rotation angles (31°, 45°, and 90°) were evaluated under as-built (AB) and stress-relieved conditions using 3D optical scanning measurements obtained before and after wire electrical discharge machining (EDM) separation. The AB specimens exhibited progressive deformation along the cantilever length, with Ti6Al4V developing approximately twice the distortion measured for IN718. The 90° hatch strategy produced the highest distortion, whereas 31° and 45° strategies resulted in lower deformation levels. Stress-relief heat treatment proved to be the dominant factor, reducing distortion by 94–97% and substantially decreasing the influence of hatch rotation.
Authors
- Constantin-Romica Stoica (ORCID: https://orcid.org/0000-0002-5038-9873)
- Alexandru Paraschiv (ORCID: https://orcid.org/0000-0003-1300-322X)
- Sebastian-Gabriel Bucaciuc (ORCID: https://orcid.org/0000-0002-4173-0056)
- Vladut Mihai
Institutions
- Romanian Research and Development Institute for Gas Turbines (RO)
Publication Details
- Journal
- Micromachines
- Published
- 2026-11-17
- DOI
- https://doi.org/10.3390/mi17111340
- Primary Topic
- Additive Manufacturing Materials and Processes
- Type
- article
- Field-Weighted Citation Impact
- 0.00
Funders
- Autoritatea Natională pentru Cercetare Stiintifică