Mechatronic Design, Biomechanical Analysis, and Kinematic Validation of a Continuous Passive Motion Slider–Crank–Lead Screw System for Lower-Limb Rehabilitation: From Post-Stroke Therapy to Potential Post-Spaceflight Reconditioning
This study developed and preliminarily validated a robotic Continuous Passive Motion (CPM) system intended for lower-limb rehabilitation in post-stroke adult patients with hemiplegia. Building upon a previous redesign and simulation stage using a virtual patient model, an adjustable structure made of AISI 316L stainless steel was fabricated, integrating the mechanical, electronic, and control subsystems for passive knee and ankle mobilization through a lead screw mechanism driven by a NEMA23 stepper motor, a TB6600 driver, and an ESP32 microcontroller operating under an open-loop feedforward control scheme. As a preliminary stage prior to clinical evaluation, functional validation was conducted through three knee therapy tests, two with a healthy adult volunteer and one under unloaded conditions, using different angular ranges (90–130°, 30–26°, and 50–70°). The device successfully executed the programmed movements without mechanical or electronic failures, completing all three repetitions in each session and recording observed differences ranging from 2.00% to 11.54% between the programmed and measured joint angles. These results demonstrate the preliminary technical feasibility of the proposed prototype. The present validation was limited to a single adult volunteer and three knee-motion tests. Future work will include validation with volunteers representing different anthropometric profiles (1.55–1.75 m), verification of emergency stop response times below 100 ms, and the incorporation of encoder-based position feedback as preliminary steps toward subsequent clinical evaluation.
Authors
- Ricardo Palomares (ORCID: https://orcid.org/0000-0001-9076-3674)
- José Cornejo (ORCID: https://orcid.org/0000-0003-4096-9337)
- Mariela Vargas (ORCID: https://orcid.org/0000-0002-9155-9904)
- Jeanette Borja Arroyo (ORCID: https://orcid.org/0000-0002-0207-6610)
- Adrian Nacarino (ORCID: https://orcid.org/0009-0000-1151-761X)
- Carol Sandoval (ORCID: https://orcid.org/0009-0004-6877-6451)
- Josue Alata-Rey (ORCID: https://orcid.org/0000-0003-1531-8516)
- Cesar Martel
- Margarita Murillo
- Harnnol Suclupe (ORCID: https://orcid.org/0009-0006-1272-1042)
Institutions
- Florida Institute of Technology (US)
- Universidad Ricardo Palma (PE)
- St Martins Hospital (GB)
- Universidad Continental (PE)
- Universidad Politécnica de Madrid (ES)
- Capitol Technology University (US)
Publication Details
- Journal
- Technologies
- Published
- 2026-11-16
- DOI
- https://doi.org/10.3390/technologies14110757
- Primary Topic
- Prosthetics and Rehabilitation Robotics
- Type
- article
- Field-Weighted Citation Impact
- 0.00