Anode-Side Strategies for Raising the Energy Density of Solid-State Lithium Metal Batteries: A Cell-Level Quantitative Assessment
A solid electrolyte allows lithium metal to replace the graphite host of a conventional cell. Lithium metal promises a higher energy density. Published work on the anode side rarely converts that promise into the energy density of a complete cell. This paper builds a single-layer cell model that converts anode-side design choices into gravimetric and volumetric energy density. A reduction of the lithium foil from 50 to 20 micrometres raises volumetric energy density by 19.5 % and gravimetric energy density by 3.5 %. Removing the foil entirely raises them by 37.3 and 6.0 %. Excess lithium costs stack thickness rather than stack mass. An interlayer that enables this reduction breaks even at a thickness equal to the lithium it removes, which is 30 micrometres in the reference case. A 5 micrometre interlayer retains 15.7 of the 19.5 percentage points available. The volumetric gain has a closed form containing only thicknesses, so no assumed density enters it. The same cell draws 4 milliamperes per square centimetre at a one-hour charge rate and 8 at a half hour rate, which sets the current an anode interface must sustain. The practical target is an interlayer far thinner than the lithium it removes, combined with a threshold current above the demand of the cell.
Authors
- Ruoyi Zhang
Institutions
- University of Edinburgh (GB)
Publication Details
- Journal
- Applied and Computational Engineering
- Published
- 2026-11-17
- DOI
- https://doi.org/10.54254/2755-2721/2027.md39003
- Primary Topic
- Advanced Battery Materials and Technologies
- Type
- article
- Field-Weighted Citation Impact
- 0.00