In-Process Application of Cellulose Nanofibrils Suited for Molded Fiber Substrates: Spreading during Pulsed Underwater Jet Deposition
Molded fiber products require PFAS-free technologies that provide oil and grease resistance. Cellulose nanofibrils (CNFs) are renewable barrier materials, but conventional coating methods are generally limited to flat substrates and require separate coating and drying operations, restricting their application to three-dimensional molded fiber products. In-process CNF application has the potential to reduce the need for these additional operations, but the spreading behavior of pulsed underwater CNF deposition during dewatering has not been systematically examined. This study investigated the effects of CNF solids content, jet velocity, nozzle diameter, and nozzle-to-substrate distance on pulsed underwater CNF deposition onto submerged porous paperboard. Laboratory experiments, complemented by finite-element simulations using a Papanastasiou-regularized Bingham model, showed that the 0.3 and 0.5 wt % CNF suspensions produced the greatest area coverage, whereas the 0.8 wt % suspension exhibited reduced coverage and a pronounced center-heavy coat-weight distribution. Nozzle diameter also influenced area coverage, with its effect dependent on jet velocity, while nozzle-to-substrate distance had comparatively little influence over the range investigated. The simulations generally captured the observed spreading behavior, although the level of agreement between predicted and experimental coverage varied with CNF solids content and operating conditions. Dimensionless analysis using the Reynolds number, incorporating concentration-dependent apparent viscosity, showed a strong correlation with normalized area coverage (R2 = 0.91). CNF-covered regions achieved a Kit value of 12, demonstrating effective grease resistance within the covered areas. These findings demonstrate the feasibility of controlled pulsed underwater CNF deposition during dewatering and provide a basis for further evaluation of in-process CNF surface functionalization for molded fiber products.
Authors
- Douglas W. Bousfield (ORCID: https://orcid.org/0000-0003-0753-1288)
- Mehdi Tajvidi (ORCID: https://orcid.org/0000-0002-3549-1220)
- Samuel Mubenesha (ORCID: https://orcid.org/0000-0002-6176-2645)
- Jinwu Wang (ORCID: https://orcid.org/0000-0002-8363-1689)
Institutions
- Forest Products Laboratory (US)
- University of Maine (US)
Publication Details
- Journal
- ACS Omega
- Published
- 2026-11-18
- DOI
- https://doi.org/10.1021/acsomega.6c08043
- Primary Topic
- Advanced Cellulose Research Studies
- Type
- article
- Field-Weighted Citation Impact
- 0.00
Funders
- University of Maine
- U.S. Endowment for Forestry and Communities