Frictional Contact of a Tube Embedded in an Elastic Layer with a Cylindrical Cavity and a Rigid Shaft Under Pulsating Loading
Tubes (bushings) seated on pins in plate-like members form attachment joints of aerospace structures, e.g., strut joints of truss-braced wings. Their unilateral frictional contact makes the contact, stick, and slip zones history-dependent. A layer with an embedded tube and a fixed cylindrical cavity is considered; the tube is seated without clearance on a rigid shaft, and a localized face load varies as 0 → P → 0. The elasticity problem is solved by the generalized Fourier method; Coulomb frictional contact with separation is enforced incrementally via precomputed compliance matrices and an augmented Lagrangian update. Compared with ANSYS, bore displacement and maximum tube stresses differ by 0.3% and 2–3%, and the peak contact tractions by 6–7% (1.7–2.8% at equal harmonic resolution). For a steel tube in a D16T layer (friction coefficient 0.3), the pressure peaks near both ends of the contact arc; on unloading, friction reverses, the stick zone grows to 135°, and the shaft force is 8–14% lower than on loading. A bearing-grade PEEK tube halves the peak pressure, reduces the tube stresses fivefold, but increases microslip 3.6 times. In an idealized pin–bushing joint, the pin force distribution depends on the loading direction, and microslip concentrates at the arc ends.
Authors
- Oleksandr Savin (ORCID: https://orcid.org/0000-0002-2664-0255)
- Vitaly Miroshnikov (ORCID: https://orcid.org/0000-0002-9491-0181)
- Ярослав Володимирович Гребенюк (ORCID: https://orcid.org/0009-0004-6032-7125)
- Serhii Savinov (ORCID: https://orcid.org/0009-0008-8260-3900)
- Oleksandr Denshchykov
Institutions
- National Aerospace University – Kharkiv Aviation Institute (UA)
Publication Details
- Journal
- Computation
- Published
- 2026-11-17
- DOI
- https://doi.org/10.3390/computation14110296
- Primary Topic
- Contact Mechanics and Variational Inequalities
- Type
- article
- Field-Weighted Citation Impact
- 0.00