Feasibility study on incorporating treated cassava peel ash (TCPA) as a new bio-filler material in the production of high-volume cockle shell bricks
Cement-sand brick production relies heavily on cement and natural sand, contributing to resource depletion and environmental impact. Although cockle shell (CS) and agricultural ashes have been investigated individually as alternative materials, few studies have examined the combined use of high volumes of CS as a sand replacement with treated cassava peel ash (TCPA) as a partial cement replacement in cement-sand bricks. This study therefore evaluates the influence of TCPA on the physical and mechanical properties of cement-sand bricks with a fixed 60% CS replacement, as adopted from previous studies. TCPA was characterised using SEM-EDX, and replacement levels of 5–25% were investigated. The estimated oxide composition, derived from EDX analysis and stoichiometric calculations, indicated a high silica content of 64.9%, suggesting potential for use as a supplementary cementitious material. Increasing TCPA content generally reduced brick density, while 10% TCPA produced the best overall performance, achieving the highest 28-day compressive strength of 16.50 MPa, with water absorption of 5.16% and an initial rate of absorption (IRA) of 4.52 kg/min/cm2. Beyond 10% replacement, compressive strength decreased, while water absorption and IRA generally increased. The incorporation of 60% cockle shell and 10% TCPA demonstrated the most favourable performance among the mixtures investigated, indicating practical potential for reducing the consumption of natural sand and cement in brick production. At higher TCPA substitution levels, SEM analysis revealed increased porosity accompanied by reduced strength. These outcomes underscore the viability of incorporating substantial volumes of waste-derived materials into brick production as a means of reducing dependence on natural resources. Nonetheless, the optimum mixture identified is inherently specific to the materials, replacement ratios, and curing durations investigated in the present study.
Authors
- Sugiman Sugiman (ORCID: https://orcid.org/0000-0002-4343-0591)
- Nelly Binti Majain (ORCID: https://orcid.org/0000-0001-8807-7202)
- Nuradila Lile
- Hilton Ahmad
Institutions
- Universiti of Malaysia Sabah (MY)
- University of Mataram (ID)
- Tun Hussein Onn University of Malaysia (MY)
Publication Details
- Journal
- European Journal of Environmental and Civil engineering
- Published
- 2026-11-17
- DOI
- https://doi.org/10.1080/19648189.2026.2756407
- Primary Topic
- Recycling and utilization of industrial and municipal waste in materials production
- Type
- article
- Field-Weighted Citation Impact
- 0.00
Funders
- Universiti Tun Hussein Onn Malaysia