Fused Filament Fabrication of Soda-Lime Glass Feedstocks
Additive manufacturing methods are rather seldom used for the fabrication of glass parts. In this work, the knowledge gained from glass injection molding and ceramic fused filament fabrication (FFF) was extended to the usage of the FFF process chain covering the individual process steps compounding, 3D printing and thermal post-processing for the realization of soda-lime glass parts. The selection of suitable feedstock compositions, containing a soda-lime glass filler and a binder system, consisting of polyethylene glycol (PEG), polyvinyl butyral (PVB), and stearic acid (SA) is essential for successful processing. Small cuboid and disk-shaped parts could be first printed and second debound and sintered to parts with relative densities between 94 up 98% depending on the initial feedstock composition. A further extension to the printing of a larger-sized micro reactor possessing internal hollow structures showed the principal feasibility of soda-lime glass FFF printing. Due to the presence of defects after printing, debinding and sintering was omitted. Consequently, further material and process optimization is necessary to eliminate part distortion and other defects, which is mandatory prior to successful process chain evaluation.
Authors
- Ralf Eickhoff
- Martin Zürn
- Thomas Hanemann (ORCID: https://orcid.org/0000-0002-8641-2094)
- Dorit Nötzel (ORCID: https://orcid.org/0009-0001-1489-774X)
- Hannes Hering
Institutions
- Karlsruhe Institute of Technology (DE)
- University of Freiburg (DE)
- Applied Materials (United Kingdom) (GB)
Publication Details
- Journal
- Materials
- Published
- 2026-11-16
- DOI
- https://doi.org/10.3390/ma19224853
- Primary Topic
- Additive Manufacturing and 3D Printing Technologies
- Type
- article
- Field-Weighted Citation Impact
- 0.00
Funders
- Deutsche Forschungsgemeinschaft