Simulation of the Motion of a Stepped Hydrostatic Thrust Bearing with an Opposite Lubrication System
The design of a stepped hydrostatic thrust bearing with an opposed lubrication system is considered. A mechanism for increasing the bearing capacity through the use of an opposed system is described. A mathematical model of the static and dynamic state of the structure is formulated. Methods for calculating the bearing capacity, compliance, and lubricant flow rate have been developed. The calculations are performed in dimensionless form. The use of an opposed system in combination with a stepped axial gap configuration allows virtually maximum bearing capacity values, for which the utilization of the bearing surface area can reach 95% or more, whereas in a thrust bearing with an opposed system and a flat gap, this value is approximately 75%, and in a conventional thrust bearing, it is approximately 50%. Thus, the use of an opposed system and a step allows for a significant increase in the bearing capacity, which is 20–30% greater than that of a thrust bearing with an opposed system and a flat gap and almost twice that of a conventional thrust bearing. In this case, compliance can be reduced by a factor of 2–3, and the flow rate can be reduced by at least an order of magnitude. A study of dynamic quality criteria has shown that there are optimal values for the pressure settings χ and ς in terms of response speed and stability margin, as well as the "compression number" σ, which determines the optimal damping of the lubricant film.
Authors
- Vladimir Kodnyanko (ORCID: https://orcid.org/0000-0002-2369-045X)
- Andrey Kurzakov (ORCID: https://orcid.org/0000-0002-3819-9743)
- Svetlana Belyakova
- Olga Grigorieva
- Anastasia Krekhova
- Natalia Merzlikina
Publication Details
- Journal
- Preprints.org
- Published
- 2026-11-16
- DOI
- https://doi.org/10.20944/preprints202611.1532.v1
- Primary Topic
- Tribology and Lubrication Engineering
- Type
- preprint