Characterization and modeling of melt-fracture-like flow instabilities in metal injection molding feedstocks
Powder injection molding (PIM) is widely used to produce metallic components with complex shapes; however, highly filled feedstocks may develop flow-induced defects during mold filling, especially in regions subjected to high shear stresses. In this study, a stainless steel feedstock, polyMIM 316 L, was investigated through capillary rheometry, injection molding experiments, X-ray micro-computed tomography (μCT), and numerical simulations. Capillary rheometry identified an operational critical apparent wall shear-stress transition range of 0.15–0.16 MPa at 200 °C, above which persistent pressure oscillations and unstable flow behavior developed. Injection molding trials followed a 2 (4–1) fractional factorial design to evaluate melt temperature, mold temperature, flow rate, and holding pressure. μCT revealed near-wall low-attenuation defects in the gate region, with mean widths of 0.045–0.113 mm; factorial-effect analysis indicated flow rate as the largest estimated main effect. Numerical simulations calibrated with measured rheological and pressure-volume-temperature data predicted the wall shear-stress distribution. Across the nine configurations, mean defect width correlated positively with simulated peak wall shear stress ( r = 0.794, R 2 = 0.630), while spatial comparisons showed qualitative correspondence between high-stress and μCT-detected defect regions. Since the numerical model does not predict defect width, the rheological threshold is interpreted as an operational indicator rather than a fully validated predictive criterion. The study provides an integrated framework linking rheological instability, μCT defect characterization, and simulated shear-stress fields under actual MIM processing conditions to identify defect-prone operating conditions.
Authors
- Andrea Scantamburlo (ORCID: https://orcid.org/0000-0001-5843-5259)
- Giovanni Lucchetta (ORCID: https://orcid.org/0000-0003-1421-8636)
- Matteo Perina
- Nicolò Bonato (ORCID: https://orcid.org/0000-0002-4567-9008)
- Marco Sorgato (ORCID: https://orcid.org/0000-0001-7293-0547)
- Rudj Bardini
Institutions
- University of Padua (IT)
Publication Details
- Journal
- Journal of Manufacturing Processes
- Published
- 2026-11-16
- DOI
- https://doi.org/10.1016/j.jmapro.2026.10.075
- Primary Topic
- Powder Metallurgy Techniques and Materials
- Type
- article
- Field-Weighted Citation Impact
- 0.00