When plastic remembers: 4D-printed PLA as a low-cost shape memory demonstration for heat transfer
Abstract Shape memory materials are excellent for classroom demonstrations. However, standard choices like the nickel-titanium alloy Nitinol are expensive. They only come as wires or springs, require a furnace to reprogram into a new permanent shape. This paper presents two experimental activities for teaching heat transfer to upper-secondary students, using a flower 3D-printed from ordinary polylactic acid (PLA). Because printed PLA is a shape memory polymer, the flower can be warmed, pressed open, cooled, and left open indefinitely. When returned to hot water, it closes by itself to the shape in which it was printed. The first activity uses this recovery to separate softening at a glass transition from melting, and to challenge the assumption that a deformation which persists must be permanent. The second activity uses the same flower to compare activation in a water bath versus an electric oven, demonstrating that two heat sources at the same temperature produce visibly different activation rates. Both activities are structured according to the predict–observe–explain strategy. The specimen uses about 8 g of filament, needs no specialist material or post-processing since no 3D printing supports are required, and the part file is openly licenced.
Authors
- Mohammad Arif Budiman Pauzan (ORCID: https://orcid.org/0000-0002-0882-0711)
- Nur Abdillah Siddiq (ORCID: https://orcid.org/0000-0001-5699-9552)
- Siti Khadijah Hubadillah
Institutions
- Universitas Gadjah Mada (ID)
- Tun Hussein Onn University of Malaysia (MY)
- Northern University of Malaysia (MY)
Publication Details
- Journal
- Physics Education
- Published
- 2026-11-16
- DOI
- https://doi.org/10.1088/1361-6552/aebd5b
- Primary Topic
- Advanced Materials and Mechanics
- Type
- article
- Field-Weighted Citation Impact
- 0.00