Dynamic wheel load response of a modified truck equipped with PID-controlled air suspension on degraded rural roads in the mekong delta

Vertical tire–road forces on rough rural roads govern road holding, component loading and pavement damage. This study examines a 1.25-ton two-axle light truck whose rear leaf springs were replaced by an electronically controlled air suspension (ECAS) with PID height control, a retrofit used for agricultural transport on degraded rural roads in the Mekong Delta. A spatial multibody model with a GENSYS-type air spring was built in MATLAB/Simulink and used to compare the original and the modified truck on ISO 8608 road classes A–F at 20–100 km/h and three payloads, with the peak vertical wheel force F zmax as the main index. The deterministic comparison was complemented by ten independent road realisations per case, a sensitivity study of the PID gains and of height-sensor noise, and pavement-loading indices, and the model was compared with road measurements on the modified truck. The ECAS lowered the peak rear wheel force in every simulated case, by up to 21.1% at no load and 19.5% at half load on rough roads (classes E and F) but by at most 8.2% at full load; the front axle, whose suspension was not changed, gained at most 7.2%. Over ten road realisations the RMS wheel force varied by at most 3.3% (coefficient of variation), whereas the peak force varied by up to 14%, so reductions smaller than about 2% are within the scatter between realisations. Changing all PID gains by factors from 0 to 100, or adding height-sensor noise, changed the rear wheel force by less than 0.001%. The reduction of dynamic wheel load therefore comes from the passive characteristics of the air-spring suspension, while the PID loop performs slow levelling. For light trucks, the benefit of an air-suspension retrofit is concentrated in low-payload operation on rough roads.

Authors

Institutions

Publication Details

Journal
Journal of low frequency noise, vibration and active control
Published
2026-11-16
DOI
https://doi.org/10.1177/14613484261509060
Primary Topic
Vehicle Dynamics and Control Systems
Type
article
Field-Weighted Citation Impact
0.00
Controls
|||
ALL TIME
JAN
FEB
MAR
APR
MAY
JUN
JUL
AUG
SEP
OCT
NOV
article

Dynamic wheel load response of a modified truck equipped with PID-controlled air suspension on degraded rural roads in the mekong delta

Danh Nguyen Thanh, Phat Khau Tan
Journal of low frequency noise, vibration and active control
Vehicle Dynamics and Control Systems
article

Dynamic wheel load response of a modified truck equipped with PID-controlled air suspension on degraded rural roads in the mekong delta

Danh Nguyen Thanh, Phat Khau Tan
article en

Abstract

Vertical tire–road forces on rough rural roads govern road holding, component loading and pavement damage. This study examines a 1.25-ton two-axle light truck whose rear leaf springs were replaced by an electronically controlled air suspension (ECAS) with PID height control, a retrofit used for agricultural transport on degraded rural roads in the Mekong Delta. A spatial multibody model with a GENSYS-type air spring was built in MATLAB/Simulink and used to compare the original and the modified truck on ISO 8608 road classes A–F at 20–100 km/h and three payloads, with the peak vertical wheel force F zmax as the main index. The deterministic comparison was complemented by ten independent road realisations per case, a sensitivity study of the PID gains and of height-sensor noise, and pavement-loading indices, and the model was compared with road measurements on the modified truck. The ECAS lowered the peak rear wheel force in every simulated case, by up to 21.1% at no load and 19.5% at half load on rough roads (classes E and F) but by at most 8.2% at full load; the front axle, whose suspension was not changed, gained at most 7.2%. Over ten road realisations the RMS wheel force varied by at most 3.3% (coefficient of variation), whereas the peak force varied by up to 14%, so reductions smaller than about 2% are within the scatter between realisations. Changing all PID gains by factors from 0 to 100, or adding height-sensor noise, changed the rear wheel force by less than 0.001%. The reduction of dynamic wheel load therefore comes from the passive characteristics of the air-spring suspension, while the PID loop performs slow levelling. For light trucks, the benefit of an air-suspension retrofit is concentrated in low-payload operation on rough roads.

Journal of low frequency noise, vibration and active control
Vinh Long University of Technology Education (VN)
Industry, innovation and infrastructure, Sustainable cities and communities
Vehicle Dynamics and Control Systems
AI Navigator

Ask Laika to Summarize, Analyze, and Connect papers live on the map.

Summarize Papers & Methodologies

Extract key findings, datasets, and comparative methods across publications.

Benchmark Rankings & Visual Analytics

Rank top research institutions, authors, funders, topics, and journals by Field-Weighted Citation Impact (FWCI) and paper volume with instant charts.

Connect Distant Disciplines

Bridge topological clusters on the map to find hidden collaborative intersections.

Laika access coming soon