Potential-Driven Current Limitation and Performance Trade-Off in Lithium-Ion Batteries with a Protective Conducting-Polymer Layer
Abstract Potential-responsive conducting-polymer layers can limit fault currents in lithium-ion batteries. However, previous cell-scale models treated polymer switching as instantaneous and did not resolve the electrochemical and ion-transport dynamics. Using a poly[Ni(CH3OSalen)] interlayer between the positive electrode and current collector as a representative case, we analyze potential-driven current limitation using a reduced one-dimensional model and a porous-electrode model of a LiCoO2/graphite cell. For this representative material system, the interlayer is described using either an experimentally based quasi-equilibrium conductivity relation or a dynamic formulation accounting for finite-rate anion exchange and diffusion within polymer domains. The reduced model reveals an intrinsic trade-off between current limitation and nominal-performance losses. For the representative 3 μm poly[Ni(CH3OSalen)] layer considered here, the delivered-energy loss is approximately 3% at 0.2C and 7–8% at 1C. During an ideal zero-resistance external short circuit, the current at 10–2 s decreases from approximately 330C without protection to 3.4C and 14.8C in the quasi-equilibrium and dynamic models, respectively. The dynamic formulation qualitatively indicates that finite polymer response can increase the initial current and early heat release, although protected-cell currents converge at longer times. Potential-driven switching alone increases the time for the adiabatic temperature estimate to reach 100 °C from 7.1 s to 47–60 s. Comparison with experimental discharge profiles reproduces the magnitude of the layer-induced voltage penalty but not its evolution, identifying the measured conductivity–potential relation as the main quantitative uncertainty. These results establish a general framework for analyzing the trade-off between current limitation and nominal battery performance in potential-responsive resistive interlayers.
Authors
- В. А. Чирков (ORCID: https://orcid.org/0000-0003-2051-3391)
- S.A. Vasilkov (ORCID: https://orcid.org/0000-0002-0928-8536)
- Oleg Vladislavovich Levin (ORCID: https://orcid.org/0000-0002-4538-316X)
- Ilia A. Elagin
- Denis V. Zhuravlev
Institutions
- St Petersburg University (RU)
Publication Details
- Journal
- The Journal of Physical Chemistry C
- Published
- 2026-11-17
- DOI
- https://doi.org/10.1021/acs.jpcc.6c05612
- Primary Topic
- Battery Modeling and Management
- Type
- article
- Field-Weighted Citation Impact
- 0.00
Funders
- Saint Petersburg State University
- Russian Science Foundation