Direct Ink Writing of Bismuth Oxide-Doped Epoxy Composites for Gamma-Ray Attenuation and Customized Shield Fabrication
Abstract Lead-free epoxy composites containing 0–35 vol % bismuth oxide (Bi2O3) were fabricated by direct ink writing. The inks contained Epon 826, 2-ethyl-4-methylimidazole, and fumed silica. Density, Vickers hardness, optical microstructure, dimensional fidelity, and photon attenuation were evaluated using 57Co, 137Cs, and 60Co gamma sources. Measured density increased from 1.09 ± 0.03 g cm–3 for the unfilled epoxy to 3.840 ± 0.009 g cm–3 at 35 vol % Bi2O3. Attenuation increased most strongly at 122 keV. Print records showed that the 30 vol % formulation extruded at a flow multiplier of 1 without a reported printing failure, whereas the 35 vol % ink became too thick to extrude during one run. The 30 vol % formulation was therefore selected for a fitted prototype plate. The installed plate demonstrates fabrication and fit; postinstallation leakage attenuation was not measured.
Authors
- Xingang Zhao (ORCID: https://orcid.org/0000-0002-2813-0339)
- Kunal Mondal (ORCID: https://orcid.org/0000-0003-1665-7755)
- Rigoberto C. Advíncula (ORCID: https://orcid.org/0000-0002-2899-4778)
- Hari Naicker
- James Riley Smith
- Trevor Wakeland
- Madison Vandergriff
Institutions
- University of Central Florida (US)
- Oak Ridge National Laboratory (US)
- University of Tennessee at Knoxville (US)
Publication Details
- Journal
- Industrial & Engineering Chemistry Research
- Published
- 2026-11-16
- DOI
- https://doi.org/10.1021/acs.iecr.6c04186
- Primary Topic
- Radiation Shielding Materials Analysis
- Type
- article
- Field-Weighted Citation Impact
- 0.00