Geopolymer Concrete Block Using Sugarcane Bagasse Ash with Partial Replacement of Water by Distillery Spent Wash
Sugar mills in Maharashtra produce two wastes side by side: ash from their bagasse-fired boilers and, where a distillery is attached, large volumes of spent wash. This paper asks whether both can go into the same geopolymer concrete. Sugarcane bagasse ash (SCBA) replaced 0–30 % of the fly ash in an ambient-cured fly ash–GGBS binder activated with 10 M NaOH and sodium silicate, and distillery spent wash (DSW) replaced 0–20 % of the extra mixing water. Twelve mixes were tested for slump, compressive strength at 7, 28 and 56 days, split tensile and flexural strength, water absorption and ultrasonic pulse velocity. The mix with 20 % SCBA and 10 % DSW (S2D10) performed best, reaching 44.8 MPa at 28 days (16.1 % above the control) with 4.6 % water absorption and a pulse velocity of 4,320 m/s. Strength fell beyond 20 % SCBA and 15 % DSW. A second-order response surface (R² = 0.80) shows that the two wastes act largely independently and that the optimum is a broad plateau at roughly 10–20 % SCBA and 2–12 % DSW rather than a sharp point. A mass balance shows that the potassium and calcium in DSW are far too dilute to explain its effect, which points to its organic fraction instead. At the binder level the best mix carries about 152 kg CO₂-e/m³, around 54 % less than an OPC reference, and 87 % of that comes from the activator. The main environmental gain from SCBA is therefore the 90 kg of ash per cubic metre kept out of dumps, not carbon. Implications for concrete blocks under IS 2185 (Part 1) are discussed.
Authors
- Kartik Pawar
- Mayuri Ahirrao
- Aditya Ranjane
- Harikesh Waghmare
- Lokesh Sungat
Institutions
- JSPM's Rajarshi Shahu College of Engineering (IN)
Publication Details
- Journal
- Zenodo (CERN European Organization for Nuclear Research)
- Published
- 2026-11-16
- DOI
- https://doi.org/10.5281/zenodo.24273097
- Primary Topic
- Concrete and Cement Materials Research
- Type
- preprint