Geometrical Inconsistencies in EN 755 Series of Standards
The seven parts of standard EN 755 that defines geometrical requirements for aluminium extruded rods/bars, tubes and profiles that are used across a broad spectrum of industries were investigated. Particularly the parts 3 to 6 of EN 755 that are devoted to give tolerances on dimensions and form for round, square, rectangular and hexagonal bars; the parts 7 and 8 that give tolerances on dimensions and form for seamless and porthole tubes and the last part 9 devoted to tolerances on dimensions and form for profiles. Unfortunately, the interpretation of requirements outlined in the EN 755 series of standards often presents ambiguities. A comprehensive review of these standards with respect to geometrical requirements consistency has revealed several irregularities. Therefore, revisions are proposed to improve structural framework and the clarity of the terminology used in parts 3 to 9 of the standard EN 755 and to make them in line with terms and definitions given in the standards developed by Technical Committee ISO/TC 213 which is responsible for standardization in the dimensional and geometrical tolerancing.
Authors
- Marcin Błaszczyk
- Zbigniew Humienny (ORCID: https://orcid.org/0000-0003-3753-1473)
Institutions
- Warsaw University of Technology (PL)
- Institute of Fundamental Technological Research (PL)
Publication Details
- Journal
- Journal of Machine Engineering
- Published
- 2026-11-16
- DOI
- https://doi.org/10.36897/jme/235973
- Primary Topic
- Advanced Measurement and Metrology Techniques
- Type
- article
- Field-Weighted Citation Impact
- 0.00