High-strength, low-thermal-conductivity porous SiOC/silica aerogel composites fabricated via precursor conversion and impregnation
Porous SiOC/silica aerogel composites were successfully fabricated through a combined route of precursor conversion, sol–gel reaction-induced phase separation, and impregnation. By varying the pyrolysis temperature, the pore structure of the SiOC matrix was tailored, which directly governed its mechanical strength. The optimal pre-impregnation properties, a compressive strength of 163.65 ± 11.39 MPa and a modulus of 5.87 ± 0.12 GPa, were achieved at 1200 °C. Subsequent silica aerogel impregnation further enhanced the compressive strength by approximately 7.9% while reducing the thermal conductivity from 0.274 to 0.261 W·m −1 ·K −1 . This work demonstrates that the synthesized composite is a promising candidate for thermal insulation applications requiring high mechanical load-bearing capacity.
Authors
- Yanyuan Liang
- Mingwei Chen (ORCID: https://orcid.org/0000-0003-0345-4115)
- Qiu Haipeng
- Jiao Yan (ORCID: https://orcid.org/0009-0003-6334-4556)
- Luyang Jiao
- Shijian Liu
Institutions
- AviChina Industry & Technology (China) (CN)
- AVIC Manufacturing Technology Institute (China) (CN)
Publication Details
- Journal
- Advances in Applied Ceramics Structural Functional and Bioceramics
- Published
- 2026-11-16
- DOI
- https://doi.org/10.1177/17436753261507817
- Primary Topic
- Aerogels and thermal insulation
- Type
- article
- Field-Weighted Citation Impact
- 0.00
Funders
- National Defense Basic Scientific Research Program of China